Vaughan240RBP Replace Saw Blade Ef 17TPI

I ran into a screw with the first blade and it took the teeth right off the blade. This is a factory replacement and the saw is back to working properly. It cuts on the pull stroke like Japanese saws, but I find the kerf and set a little too aggressive for fine work so I use this for rough cutting, and then, if necessary, do refining cuts with a fine tooth Dozuki or use the crosscut table at the table saw. Also the thin blade will bend so cuts need to be done slowly (as they should be done).

OK .. it's not complicated. This "Bear Knife" is about the handiest tool in my big box. Between it and your Dremel, you don't need much else except maybe a good pocketknife. My Knife is at least 10 years old, and I finally decided to replace the blade. Voila .... back to perfect. Good buy for the money.

Blade was delivered on promised schedule. It’s sharp as original when new. Seems a tad expensive, guess that means the handle is the cheap part.Overall the saw is very handy and I use it often for quick cuts. Original blade was dulled by cutting composite flooring that seemed very abrasive.

The unit cost per blade is too high. I will recommend it if the cost go down by at least 20%.

This saw is strong, very sharp and very useful in wood cuttings. I use them every day in my construction job.

Have a double sided blade but seldom use coarse side and fine teeth have been abused, so ordered this as replacement. Good choice!

been using this Vaughan pull saw for 25 years. can't begin to list the cabinetry work I've accomplished with just this blade alone. and I have every power /battery saw there is. if careful, I've had blades last 5 - 7 yrs.

Wow, great transaction. My product arrived a day earlier than scheduled, which was great because I immediately started using the saw blades within an hour after receiving them.