AUKENIEN1250pcs 25 Values 1/4W Carbon Film Resistor Assortment Kit 1 2.2 3.3 10 22 47 68 100 120 150 220 330 470 560 680 1K 2K 2.2K 4.7K 5.6K 10K 22K 47K 100K 1M Ohm 1/4 Watt 5% Resistors Pack

Likes: range, quantity and fast delivery at a competitive price.Dislikes: none.

No relly happy

Didn't really need these as 1 Watt, but the person they were got for has defective sight and modern resistors are very small, often blue and impossible to read if your eyesight isn't that good. These solved that issue for someone who is experimenting.As a foot note, I do wonder why in 2024 the archaic colour code is still used. I'm sure nowdays the actual numerical value could be printed on quite easily?

thank you

This is great for my electronics

Can you believe it, but the only values I needed where 470 and 330 ohms and guess what, the 330 ohms were missing from my set. So in the end I had to get another set of 1W resistors elsewhere. I suppose if you just fancy pot luck on there being the resistor value you want in the box then it is worth a gamble. For me it didn't pay off. Caveat Emptor! Buyer beware.

Brilliant

Upon looking into all the values I notice 3 values had only 4 resistors not 5. I’d expect higher quality control when counting to 5.I needed these urgently so I won’t be sending back however I definitely won’t be buying again.

Nice,selection of resistors at a great price.

Contenuto completo di quanto proposto dal venditore, qualità discreta con valori di resistenza entro il 5% (parliamo di un kit di resistori da 5W) e comunque entro la media standard di questi prodotti.

- Artikel wie beschrieben in sehr guter Qualität

Rien d'autre à dire que le titre.

I've bought a bunch of usb-c devices only to find out they only charge with A to C cables, not C to C cables with pd charging. So that meant I needed to bring an extra usb-c to a cable plus a USB-a charger just to get them charged. Then I found out the reason they don't pull any charge is usb-pd chargers don't just produce 5v automatically. To tell it your device wants 5 volts, there needs to be 2 5.1K Ohm resistor soldered to certain pins. One between cc1 pin to ground and the other from cc2 pin to ground (Labeled A5 and B5 in the schematic) In most cases, these devices use a 6 pin usb-c connector. You can follow my image for those. Keep in mind that different devices have different amounts of room near the port. In my cases so far, It was easy to fit these resistors right behind the c-port and they are not much wider/taller than it. In other cases, you may need to use an smd resistor, figure out which pins are the cc1, cc2 and ground if the pin layout is different, etc. The picture is from my usb-c mouse and now it can charge with the same cable/charger as my laptop. Happy times! Hope this help someone out there!