Busboard Protot SB400 Solder able PC Breadboard 1 Sided PCB Matches 400 Tie-Point Breadboards with Power Rails

This PCB (Printed Circuit Board) is very convenient for hobbyists and prototype developers as the layout matches a standard breadboard, such as  BB400 Solderless Plug-in BreadBoard, 400 tie-points, 4 power rails, 3.3 x 2.2 x 0.3in (84 x 55 x 9mm) .The PCB can actually be laid over the Breadboard (copper side down) and then be gently lifted off (once all of the components have been placed and the circuit tested) to keep all of component leads and jumpers in their proper places. Bending the wires poking through will help keep them in place when you flip the board over so the leads can be clipped and soldered into place.Highly RecommendedCFH

Same problem as an earlier reviewer. The board width at the power rails is off just enough (too short) to not fit a Breadboard Power Regulator. The reason I bought is to distribute power from a regulator through the rails. These are a great idea, poorly executed.

The copper comes out easily on the through hole. I have had to connect leads after the copper came off with solder bridges. Since I wasn't actually wanting to reuse them for more than one project, this isn't a huge problem.It's annoying that when you eventually need to resolder / desolder (removing a 7805 regulator for saving battery life), you pose a great risk of damaging the board though. I was wanting to maintain a project on these boards without needing to use the solderless since the connections are sketchy and the jumpers are long and cumbersome for a small device that needs to move around.

For someone who is not super skilled at soldering - this prototype board is a godsend! I love that it matches to a breadboard and has similar rows/columns all ready to go. It's super easy to solder to the copper points. I've done 3 projects and I had such a great experience with it on the first I have come back and bought another for each new project. This is basically the final part to my project - soldering to this guy up and then I throw it in a project box.The hard part of your project should be planning and designing, not soldering. This prototype board makes the soldering part easy! I can't imagine switching from these even as I get better, but who knows... either way I would absolutely recommend these to folks, especially people new to soldering.

It has no plated through holes and has no tin plating over copper. Very hard to solder even with flux.

Works well, i made a "Boarduino" with it with motor controller on 1 board. Great to move a prototype 1-1 to a more sturdy version.No problems with soldering and so far holds up well.

Good quality board but it’s only 1 board for the price it wasn’t a good value.

If you are looking for a PCB to seamlessly move your breadboard prototyped circuit to, this may not be the product for you. The spacing is off just enough to be annoying. I use the Solarbotics Breadboard Power Regulator to power my solderless plug-in breadboard when prototyping, and when I tried to move my project over to this solderable PC Breadboard (same manufacturer!) the spacing of the pins width-wise is off enough that the power regulator won't fit. Very frustrating. I won't be ordering this model again.