5Pcs 2 Rows 12P Wire Connector Screw Terminal Barrier Block 300V 10A + Insulated Electrical Wire Connector: 22-16 AWG Red/Blue 120 Pcs

liked the way it is to use. Problem with some of the screws strip out.

I was disappointed with the quality of this purchase. Upon opening the package I found several loose screws and metal sleeves which had to be reinstalled before the connectors could be used. While not a difficult task, it does seem to me that quality control is lacking.As I used these connectors for carrying low voltage electricity, they served the purpose. I found tightening the screws difficult. While the screws appear to accept both slotted and philips style screw drivers, I was unable to find any screw drivers that actually fit properly without applying considerable pressure. Both types of screw drivers would otherwise slip out of the screw slots.Not included in the Amazon description of this item is the correct size screw to fit through the attachment holes. For the connector I purchased, it is a number four wood or machine screw. Different size connectors may have different size holes.If it is desired to separate the connector into smaller pieces, I would, based on my experience, recommend a razor style saw or a hack saw.The seller did include a package of what appears to be 0.11 quick connect male wire connectors. I found them useful and especially helpful when using small diameter stranded wire.

I have not used the item but appears would be fine for connection through side to side. I ordered 8mm pitch jumper bars. They do not fit and there was no mention of the pitch, so I assumed it was standard. These strips are more like 9 or 10 pitch. The connectors are probably worth the price, though a bit long to stay on one side of the strip but easily shortened. May have use at some point in the future after they go in my odds and ends electrical collection.

How can you go wrong with 5 terminal strips including crimp connectors for less than $10?I used them to hook up 6 short LED strips in a project I was building. I used the crimp connectors and short wires to build a "bus bar" for one side and connected the leads to the other side. All worked well except when I tightened one screw a little too tight and cracked one connector (hence 4 instead of 5 stars).All in all a huge time saver for me, I will use these again.

First off the strip I had expected to be rigid but it was flexible. After trying to affix it to a board it looked like a snake shape. Trying to use crimp pins, there was not enough room in the channel to allow them in from both sides fully.. Discarded these and moved to a rigid strip on Amazon Dinkle Assembly DK2.5N White/Black 10 Gang DIN Rail Terminal Blocks, 12-22 AWG, 20 Amp, 600 Volt,

Do yourself a favor and DO NOT even waste your money and time on these! This cost me $6 and isn't even worth $1. It's typical cheap crap from China that instantly breaks.Upon receiving my package, it was open with one of the full connector blocks missing/stolen. Also, there were many screws missing and lose in the open bag. I had to contact Amazon Customer service about this.I went to use this for my electronic project, and the first wire that I screwed in broke the terminal! You can see in the photos that are attached. Did I screw it in too tight? Not at all. You want the connectors to be tight, so the wires don't jump out randomly! Perhaps the question should then be: Did I scre it in too tight for these cheaply made connectors? Yes! So if lightly turning the screwdriver (without cranking on it) is "too tight" then that renders these terminals useless.Don't buy them just solder the wires and save yourself the hassle of this cheap crap. Give yourself peace of mind, knowing that your wires are soldered properly and not going to come lose with these useless connector blocks.

Easy to break the inner metal sleeve if you tighten it to much. Even with the smallest screwdriver seems to easy the break.

They are very small. To small for my current application.