Patio Heater Reflector Shield, Aluminum Heat Reflector Shield Top for Propane Outdoor Heaters,Dome Replacement Parts(3-Hole Mount，33" Diameter Round)

The right fit. Perfect.

The media could not be loaded. I modified this to be a heat deflector on a 22” diameter smokeless fire pit. Assembly wasn’t difficult (9 screws & nuts). I added three 10” hairpin furniture legs (pack of 4 also on Amazon $21.95). Drilled three holes for each leg. Used 8-32 x 1/2” machine screws, nuts & flat washers. Also added a 1/4” x 2” eye bolt & two hex nuts to the top. Unit light duty but sufficient and much less expensive that buying brand-name.

Fit my old patio heater that has fallen down more times than a geriatric president that shakes hands with air. The blue plastic came off easily enough. I put my patio heater in my garage since it has been windy here, and I don't want to buy this again.

I needed to replace a hood that was ripped off and damaged by a windstorm. This item is a bit smaller that advertised (diameter of 32 inches vs. the 33 that's advertised) and is much flatter than the dome shape of the original (whose diameter was 34 inches). I needed to drill a few holes since the pre-drilled holes did not line up but that was easy.The parts arrived well-packaged and were not bent or damaged. All needed parts/screws etc were there.As others have noted, it was a bit difficult to remove the blue protective film, especially from the circular center. A few of the pieces were warmed in the sun and the film seemed to peal away more easily than those that were still cool.Wear GLOVES, especially when peeling the film, and be careful when handling the pieces. They are stamped sheet metal and have sharp edges that will easily slice open fingers.There are no instructions on assembly but assembly is pretty straightforward and besides, the item listing on Amazon has a video that shows step-by-step assembly. (Amusingly, the wing-nuts are called "goat horn shape screws".) Note that he wears gloves.All in all, it gets the job done, nothing special or exceptional.

High winds knocked over our propane heater and the only damage was to the top. Brent badly enough that it was toast. We order this and was greatly pleased with the quality which was actually more sturdy that the original. (Note this review is after several months of use). It fit perfectly. My only ‘complaint’ is that the panels did not come with news bolts. We used the existing without issue but they were rusted and would have liked the option of getting newer ones

Arrived without damage. All parts needed to assemble were included and fit on existing holes. Compared to the size of the original 1" less but unnoticeable. Clearly documented 53" and our original must have been 54"

Our heater got knocked over in a bad windstorm and the heat reflector was damaged. The hubby bought this and it was easy to put on and saved us from having to buy whole new heater. This is a good thing because being out on our deck under a working heater and near a fire pit helps make the brutal winters seems less dreary since we have sub freezing/below zero temperatures for several months in the winter. My only issue with this item is that the diameter is a little smaller than the original reflector so a little less heat gets reflected downward which is slightly noticeable. In a less frigid climate, you probably wouldn't notice it at all :-)

Received patio heat reflector and it has a dent in it. It was usable so i just used it anyway. Didn’t have time to do an exchange. It works as it should, just has a dent.