Wztepeng Boat Motor Carburetor compatible with Nissan Tohatsu Mercury 4 Stroke MF3.5 MFS4 MFS5 NFS4 3.5HP 4HP 5HP 6HP Outboards replace 3R1032001 3R1-03200-1 3AS-03200-0 3R1-03200-1-00

The media could not be loaded.  So I ordered this carburetor for a friends Merc 2.5hp outboard 4 stroke that was all gummed up and hadn't run for 7 years. I removed the carb and flushed out the tank and installed and put fresh Ethanol free gas in it. I spend the full shut off and let gas get into he bowl and pulled the started rope. 1 Pull is all it took and let sit and warm up and run for 5 minutes. I set the idle and that was all it took. I have the exact motor and without any problems and turns just as good so I ordered one for mine and the same result and used my original carb as a spare. We use these for RC boat retrieval boat motors and I let them run all day long from 8-5 and is what I decided to order one for mine. I couldn't be happier with this carb.

PRODUCT ARRIVED ON TIME. EXACT FIT TO ORIGINAL NO ADJUSTMENTS NEEDED

Quick delivery. Had the old one removed and the new on in 10 minutes… fit perfectly on my Mercury 3.5 hp four stroke.Started up without issues. Slight adjustment needed…. Works great!

If you ever have trouble with your outboard motor, it’s most likely carburetor issues. This was a perfect replacement for my Mercury 3.5 horse outboard and it runs like new again.

Wanted to upgrade a Tohatsu 3.5hp with this 5hp carb. Works OK over 2000 rpm, but simply cannot get it to idle. I think it's hit or miss with one of these knock-offs.

The new carb. Had bigger ports than my old carb. After removing the old intake gasket it was a perfect fix with the new gaskets that came with it behind my old gaskets my intake had a bigger ports so now 2.5hp mercury 4 stroke is now a 3.5 to 4hp mercury 4 stroke the carb. I ordered was a for 3.5 to 4.hp a perfect fit the picture are my old carb. The new carb has a much bigger port which I didn't think to take a picture before installing

I'm skeptical about stuff like this but I ordered it anyway. It showed up the next day amd I found that the exit from the carb was slightly smaller than the OEM carb. I installed and tested, motor has full throttle response compared to dying out when I passed high idle. I'm satisfied with my purchase and I have a motor that works well now.

The media could not be loaded.  Came with 2 gaskets, install was easy. Only had to adjust with idle screw at the top to lower the idle rpm speed and sprayed starter fluid and she fired up.

The media could not be loaded.  Installed this carburetor on my 2005 Tohatsu 6HP long shaft Outboard.Works perfectly ….I would buy again if ever needed.

Part arrived on time and was as advertised. This carburettor worked fine. Good cheap solution.

Exactement le même modèle et livraison rapide 5/5

Pour l'instant fonctionne bien. J'ai dû plier un peu la tige qui relis le carburateur à la manette du gaz. Elle empêchait de ralentir le RPM. Ensuite, j'ai pu ajuster le RPM facilement. Il reste à voir dans le temps, puisqu'il n'y a pas de pièce disponible pour les carburateurs chinois. 3-4 fois moins cher que l'original Mercury 3.5 de 2006

Only required a small adjustment of the air/fuel screw to work perfectly. 1and 3/4 turns from fully seated works great on my motor. Slightly different than stock but fits idles and revs great.