TRUE LINE AutomotiveBlack Door Edge L Shape Molding Kit with 3M Tape (12 Foot)

Great product! Easy to install and has a clean finish protecting your vehicle!

Installed on a 2014 Toyota RAV4 without issue using 12' section. The 12' section was the perfect amount for all (4) doors and the lower lip of the rear hatch with no waste. While the directions for installation are minimal, there are a few things you can do to make it easier.♦️ Make sure it's at least 60 degrees before installing it. This makes the molding more pliable and easy to maneuver around corners, and also helps it to adhere to the edge of the door.♦️ Place on edge of door while it's still in the large strip and cut the first piece on the shortest door (it's just easier). Then use that as a guide for the matching door on the other side of the vehicle and cut a second piece. Do that for the next door on the same side of the vehicle and again, use that as a guide for the opposite side of the vehicle. You will then have four pieces of the correct lengths by only measuring for two.♦️ Have a rubber mallet on hand OR be prepared to tightly grip the edge and run a microfiber cloth over it several times gripping on it to make sure that it's adhering to the door. Let it sit undisturbed for 24 hours out of the rain (no car washing either) for 24 hours if possible.♦️ MOST IMPORTANTLY use rubbing alcohol over the edges of your door to clean off all wax and dirt prior to trying to install this product. Let the alcohol dry fully after the first cleansing and then do it a second time, again letting it dry fully before attempting to install the product.♦️ Start at the top of the door and pull the 3M (sticky) strip back a few inches at a time as you place the molding into place - firmly clamping with your fingers as you go. Take your time and make sure the bend in the "L" is flush against the edge of your door. Rub out any bumps as you clamp and move down the door.If you take your time and prep the surface, you'll get great results with this product. It's much easier to use than 'U' shaped edge kits and infinitely cheaper than the dealer offerings!

Easy to install looks great and should last if careful cleaning the doors prior to putting on. Have a new 2021 subaru outback. I installed this morning and like the contrast vs Subaru's only choice to match the body color ( it is autumn green) which looks really good and should provide the extra protection for the doors I want. Have previously had on 2010 and 2011 outbacks and have been very pleased with the product.

Replaced damaged moulding on a truck cap, looks good and went on easily and securely, did it in warm weather helps by unrolling it to warm up and uncoil, then cleaned the cap with acetone where it was to be fitted, let it secure for one day then fitted it back on the truck, perfect!

Very functional product that will protect the door edge well. Installation was easy. I did use 3M Adhesion Promoter for a stronger bond. Blends very nicely with my black CRV. Recommendable.