Cre8tive 24" x 118" Wide Silver Aluminum Foil Contact Paper Peel and Stick Waterproof Oil Proof Stainless Steel Wallpaper Heat Resistant for Kitchen Stove Backsplash Renovation Fridge Dishwasher Decor

IKEA stopped making brushed nickel legs for the kitchen cabinets - just had the black feet you are supposed to hide with the plastic toe plate. Covered the black legs with these and it looks legit.

Good solution for blending in non Stainless Steel components.Installation does require care to avoid bubbles. Two person job but very doable for amateurs (Myself and Wife).Looks great.This project: covering hardboard/hardboard box to extend an outdoor SS vent chimney cover. No blue smoke during while applying it :-)Definitely would do this again on the next project.

I have use a number different product on the area and until this roll right here I have been unhappy. But this I have to say wow...I did it by myself it went on so smoothly. Now I am about to post pictures with this... EVERYONE who read this what I used this on was a table I made on my own I have tryed other things to cover it, only to have them not work! But this covers it perfectly stays stuck I have other things under it that's why does look smooth in some places it not the product it's the surface.. I would definitely RECOMMEND THIS I am Actually going to order another Roll!! Thank u. Hope this makes sense....

It was too thin and looked really cheap when I attempted to use it to cover my white fridge.

worked like the 3M version that I have used in the past, just a bit thinner. No issues installing - like all self adhesive vinyl, you must know how to use patience and good technique if you want a professional finish. I believe those that have given this product a bad review just did not know how to install it the correct way. Once it adheres, it stays... don't try to remove it shift it, that will not turn out well...

The material is like a roll of regular foil paper. It thin and flimsy.

Don't use it unless you are covering glass. shows every imperfection your wall has, every lump, bump, and uneven spots. It sticks great. I tried to remove it and it took the paint off the wall.

If you expect this to be more than contact paper you may be disappointed. If not, it will meet expectations. The only criticism and head scratcher was a coffee cup sized circle either scratched or stained into the material, about 4 feet from the starting end. Seemed strange as no other imperfections have shown up in the half roll that's been used.The material is fairly easy to apply if you measure precisely and precut your panels. A 2 person installation allows one to peel the backing and keep the panel aligned while the second person applies even pressure to the finish surface.My Hints: A good method to press the material down smoothly is to use a tightly rolled bath towel as a squeegee. It doesn't mar the surface and pushes air bubbles out evenly. Also, clean and smooth (fine sanding may be required) the surface being covered until it is glass like. Any dimple, spec of debris, imperfection, etc. will leave a noticeable bump and eventually delaminate the adhesion. Lastly, work and rework any overwraps on sharp edges. These are very difficult to ensure the adhesion doesn't pull loose making a smooth finish look bad along the edges.

Ok 👍

Updating our camper, used it on the fridge door. Looks great! Pretty easy to use. Would get again.

Fairly easy to work with- could have been a bit thicker, but did the job, and looks good. Recovered RV fridge.

looks great and really easy apply , I used a credit card and an exacto knife that's all

This made such a difference to my large, all black fridge. I have a black and stainless steel stove and dishwasher and wanted to tie them together. Not only does it look like a million bucks, it took away alot of the overall presence of the fridge giving my galley kitchen a more spacious appearance.It was very easy to apply and all I used was a dish towel to smooth it out. No muss, no fuss. Nice product!