10 Pack BNC Male Crimp Connector 50 Ohm BNC Connectors for RG58 RG142 RG400 LMR195 KSR195 3D-FB Coax Cable

I bought these to have on hand when needed. They have been great to have. The look and feel just like any other BNC crimp connecter I have ever used.

muy buen conector para mis cables sdi y rf

Good quality, performs very well. Crimped a couple of these on a 10 foot length of RG400 aviation antenna cable and used it to connect an outside comm antenna to a transceiver that could measure SWR (Standing Wave Ratio). A perfect SWR match between a radio and an antenna is 1.0, and using the cable with a pair of these BNCs scored a perfect 1.0. Hadn't seen that before.

These are marketed as crimp connectors (both center pin and ferrule, using .066" and .213" jaws, respectively). Snapped a center pin while crimping. Be sure you're crimping as far down the wire as possible (towards the bottom of the pin while staying in the provided groove) or it may break.

Excelente producto alta calidad y desempeño

The center pin has to go through a hole in the teflon insulator. The center pin is 0.090" in diameter, but the hoe is only 0.083". I was able to make these work by reaming out the hole with a #43 drill bit, but one shouldn't have to do this.

the description is a lie. These connectors do not fit RG-58. the crimp jacket does not fit over the cable and the connector side dingus does not fit over the insulation between the shield and signal.

I liked these connectors. My aircraft connector crimp tool seems to put the correct crush on the crimp. They did seem to have a fairly snug fit. I can't remember if shrink tubing was provided but you definitely want good quality shrink tubing with glue in it.