TrijiconNight Sights/Suppressor Sights/Smith & Wesson Bright & Tough Night Sight Suppressor Set with White Front, White Rear & Green Lamps for S&W M&P, SD9 Ve & SD40 Ve

I hesitated for at least 6 months because I had no idea if this fit the shield or not. After doing some measurements and some internet research, I found that seemingly NOBODY makes this style of sights for the shield. I decided to give it a try and I can confirm, YES THEY DO FIT THE SHIELD. The front sight is a no brained and fits flawlessly, the rear is just a hair wide but it doesn’t protrude past the width of the slide. It does not protrude behind the slide either, it fits nestled perfectly (although it does look sort of goofy) on the slide. As far as how well they work, with any 1.5 inch suppressor and a gen 1 shield, it peeks out just above the can so it functions just as designed. I searched extensively for this information so I hope this review helps anyone looking for this same answer

Nice upgrade for M&P 1.0 when adding a threaded barrel. Installed by using a nylon punch and hammer with the slide secured in a vice with soft jaws.Measured for center with digital calipers and took my time to ensure the sights were drifted to the stock positions.Sight acquisition is quicker with these installed. They clear an obsidian 9 p

I should have bought new instead of like new. Product was obviously used and not like new. Has install slide marks where product meets the pistol sight housing. Missing screw to tighten rear sight in. Missing trijicon stamping on sided of product. Product was tossed in its plastic factory box and all over the place. Came with two screws that dont even belong to this product. Tritium still has glow but am unsure of the date of expiration. I should have bought new (my mistake) but when I see like new this was the opposite.As I figured this got posted to the new Trijicon item page: I bought a secondary used item from this page as other options for purchasing this product. So I added 3 stars instead of 1

These will co witness with holosun 507k on the Shield and work great.

Without extensive modifications this will not fit on the 40c in the description it said that it would fit but that is not the case, the base is too thick and does not have the correct angle to fit into the front post

Awesome buy, came in original packaging in new condition. It is 3/2020 and the date on them were 19. Glowing bright and brand new!! Both had their original markings on them from factory, (no date scratched off)

I put these sights on a full-size Smith and Wesson M&P 9mm. For some reason, I shoot much tighter groups with tall sights. Anyway, these work great and will work to aim over top of most common suppressors.

The sights work as I expected. They are viable just over the top of the suppressor. Please, get a gun smith to install these or buy a sight tool.