BestEquip Rotary Table 4inch(100mm) Horizontal Vertical Milling Table 2/5inch(10mm) 4-Slot Milling Rotary Table MT-2 Rotary Table for Milling with Indexing Plate Set for Precision Milling Drilling

Very nice rotary table! I found no issues with it except for the hole in the indexing crank handle for the set screw. It arrived very fast, had a lot of oil on it but it wiped off easily. Oil is good when it comes to machinery parts. Very well machined and good accuracy. The only issue I found was the hole for the indexing crank set screw seemed to have some thread issues. I used a plastic twist tie with a fine wire in it to MacGyver it, doubled up the twist tie, stuck it in the set screw hole, then threaded in the set screw. The crank handle cut it off on the inside when I inserted it, then clipped off the ends on the outside with set of small flush cutting diagonal wire cutters.

Im not using this for machining, however it is being used on a low force high accuracy application. I tried some other models with horrible results. Under no load, this unit performed very well and with no backlash or slop.

It is a nicely built machine. Just a warning: the problem with the one I got was that the worm gear ratio was 72:1, even though the accompanying manual identified it as a 90:1 (a more common ratio..) I ruined a piece while using the dividing plates before I realized this.