2-Way Crossover | 12dB, 8 Ohm, 200W, 3kHz

I built some boxes and loaded in the crossovers and the drive units. And added black carpet covering. Looked terrible once i put them up..lol so i broke them apart and had a rethink as these are for Dolby Atmos speakers. The Crossovers work fine as expected.

Llevo usando el filtro casi 2 meses, funciona perfectamente y lo considero una buena compra en relación calidad-precio

Il taglio di frequenza è piuttosto preciso, con 3 khz il tweeter è al sicuro da eventuali rotture. il suono risulta piuttosto equilibrato e piacevole, consigliati

Para lo que quería bien

Once you get iver the fact the finishing isng great, these are potentially very good crossovers.A few issues were resolved with 10 minutes of soldering. Firstly, the ceramic resistors are HEAVY, and fragile, this means they can easily under their own weight fall to pieces if subhected to a relatively low force inpact, for this reason I wouod suggest doing what i did, which is to remove them, clean the pcb and then glue them back down using hot glue, then resoulder them. This removed the risk of vibrations and shocks damaging them over time.Secondly, one of the coils is attached with a cable tie, again i removed it, cleaned the pcb and then used hot glue to fix it in position, again removing the risk of vibrations causing damage over time.This is odd, as one of the coils is actually already glued down, so why the manuefacturing process wouldn't also glue the other coil and the resistors is a mystery.Overall the are very good, cutoff is pretty spot on at 3kh and they are actually very well made minus a few tweaks.I would certainly buy them again in the future, bearing in mind the basic mods I would have to do.