Edge Supply Walnut Wood Veneer Sheet Flat Cut, 24” x 96”, Peel and Stick, “A” Grade Veneer Face – Easy Application with 3M Self Adhesive Walnut Veneer Sheet– Veneer Sheets for Restoration of Furniture

Nice product. I used the peel & stick walnut veneer to upgrade some cabinets. Cuts easily if you take your time with new, sharp blades. I used a satin, water based finish with minimal sanding. Very happy with the results.

Pros- good wood quality. Prepped project substrate with three coats sanded polyurethane that provided smooth surface for excellent adhesion of 3M PSA. Veneer cut easily with box cutter/heavy scissors leaving very clean edge. Veneer flexed nicely in vacuum press to adhere to waterfall edge and curves.Cons- eighth of an inch gap between edge of veneer and adhesive in some spots. Probably would have been okay without, but added bead of glue anyhow.CAUTION- you basically get one shot at getting placement right once you remove the PSA backing. The PSA adheres instantly so ensure you’ve got your veneer cut and placement right BEFORE you peel.Excellent product that I’ve already purchased again for next restoration. It’s a little pricey, but I didn’t want to mess with glue required for less expensive non-PSA veneers- anything to reduce the number of variables for my first veneer project. Very pleased.

Used this to complete the restoration of a set of Pioneer CS-66 speakers from 1969. First time trying to apply veneer and it came out great!! Watched a couple of YouTube videos, took my time and was impressed at how well it came out. It was easy to use, and the adhesion was great. Next up is a Pioneer SX-880 receiver!!

The product is more than acceptable from a cabinet making perspective. The only issues I had were with hot glue on the surface and about 1/4” of the entire edge did no have glue. So the surface had to be scraped before it could be rolled. Which seems like sloppy handling on the manufactures part. And a fraction of what you buy is essentially unusable. One could argue that the edge could be overhang, but I came in 1/2” just to make sure the edge had glue. So it was wasted. Would I buy it again? Yes. No doubt.

I have a 96" by 24" desk and thought this sheet would cover the whole thing but the veneer I got is actually 94.5" by 23" and wasn't square to boot. In addition, the adhesive doesn't go all the way to the edge which means you lose another half inch on the sides. It's a fine veneer and looks great otherwise but now I have gaps around my desk and will need to figure out another way to cover them. Be careful if you're getting this for an 8'x2' piece of wood because it won't fit. It's fine otherwise.