YOUQUKEJI2430 7200KV 4P Sensorless Brushless Motor with 25A Brushless ESC Electric Speed Controller for 1/18 1/16 RC Car Truck

Easy to install and to program with a program card. Wish it would have came with the program card. Had to by it separate. Using it my losi mini drag car. Not as fast as the stock motor. But with gearing change should be a rocket. Probably better for a buggy or short corse truck.

Easy swap into the Teton. You will need some zipties to hold the esc down. Esc needs a program card. Motor runs a little too hot, suggest a 24mm heatsink. Slightly faster than stock, way more punch. Get a 2000mah li-ion pack and run over 20mins

Couldn't get my controller to connect.According to the instructions, I needed to but some kind of adapter to set up the receiver. I was not aware until I read the paper inside of box:/

Used on a Losi mini T 2.0. Factory brushless motor burned up after 2 days. For the piece this is amazing... However there is a delay while under wide open throttle. Factory brushless motor did not do that. I ordered a factory replacement but I like how this brushless motor is separated from the speed controller. Also the whole kit was less than 1/2 the price as a replacement losi motor. At the time of purchase this kit was $36 and the losi motor with shipping was closer to $90. Nothing to complain about for the price.

My buddy gave me a couple Dromida BX4.18 buggies to get me back into RC. The brushed motor and ESC were shot, so I ordered this. Very impressive package for the cost. From a crawl through the house, to hitting silly speeds on the street, I couldn't be happier with how this works for an 18th scale 4wd buggy. I was expecting next to no measurable control, but this thing really rocks. I'll update this review as time goes on to judge reliability.

Put it on a 1/18 little monster truck and changed the whole driving experience. The system is great but some of the cables could be a little longer. Had to do some modifications (nothing major) due to the fact that I couldn’t place the on/off switch in a comfortable place.

Perfect fit to upgrade from the original brushed LaTrax esc and motor. There is no modifications required if you have the 14t pinion gear. The original 9t pinion will not reach the spur gear without modifications. Same shaft diameter on the motor, and the ESC and diode can mount where the original esc was. No sure on longevity yet, will update if there are issues.

I do not like the fact that I have been delayed in the enjoyment of my rc truck. I do not like to get parts sent twice to get parts that work. If your inventory has defective components maybe they should be tested before sending them out.