UTGSuper Slim 13 Slots Picatinny Riser Mount

The riser fits well and moves the optics high enough to see through at a neutral position.

If you need a riser this is the one I've found that's worth your hard earned money. I wasted too much money on less expensive (cheap) risers that were less than adequate for me to trust for my expensive optics with. I found these to be a solid riser with the strength and fit I trust to hold onto my expensive optics at a modest price.

The product is exactly as described, running the whole length of the top rail of an upper. I am using it to raise a red-dot and magnifier.The product itself looks great, so you won't sacrifice "tacticool" by adding the riser. It installed very easy, using three torx screws to tighten. Torx screw wrench and extra screw are included. It is extremely light-weight, yet does not seem cheap.I haven't fired the rifle with it installed, so I can't speak to how durable it will be in the long run.

Just what I needed to raise my scope to comfort eye view. Sturdy and perfect can’t ask for any better. Recommend low strength blue loctite to ensure stability.

The mount is well machined with nice bevels to remove sharp edges, and the recoil lugs set it aside from a lot of other risers out there from more expensive brands. BUT, since the clamping bar is across the entire length of the unit and it uses relatively wide, countersunk screws, the clamping bar raises high enough that for many common one piece scope mounts or QD magnifier mounts, the mount and clamping bar collide and it won't fit.I'd suggest downsizing to a T10 instead of a T15 sized head, and possibly using a counterbore instead of countersink screws. It's a shame cause I really want to like this mount but can't for my desired dot/magnifier setup

Works great...holds my cantilever 30mm mount and my 6-24x50 diamondback tactical scope perfectly on my AR...nice and high and easy for my eye...get one!

I wanted to replace the open sights on my Diamondback DB15 AR. This rail was the trick to getting the red dot scope elevated enough to set the dot squarely in-between the front sight wings. I used an A2 pin removal tool to take out the front post, and the dot fell almost immediately on center, exactly replacing the top of the pin. Now just put the dot on the target for nice, tight groups. This 0.83" riser was exactly the correct one. I also bought the 0.75" riser and it was a tad low for my application. What I found is that it fits nicely onto the rail, and when snugged down, it remains solid, and has remained so for the last 100 or so shots. I may decide to add a big of loctite now that I have decided to make it a permanent optics solution, but it's probably not necessary. I will wait until the next service.

Do your research. This a great fit and awesome addition. Be patient and think it through before trying to install. Great product.

Ya this worked like a charm!

Echt zu empfehlen, top Produkt !

Sehr gutes Preis-Leistungsverhältnis und super Verarbeitungsqualität. Ich nutze die Erhöhung auf einem Schmeisser AR15.Lässt sich perfekt auf die Picatinny-Schiene setzen, mit Drehmoment angezogen, bei .223 schussfest und wiederholgenau! Perfekt.

I'm extremely impressed with the quality of this product, easy to attach and lightweight, fitted perfectly on my picatinny rail and rock solid when tightened on. I used it in conjunction with 2-piece 1-inch high mounts it is perfect for airsoft.Also only took 2 weeks to arrive even though six weeks was stated.Admittedly not the cheapest way of raising your scope but worth every penny, remember you get what you pay for!! would definitely buy again and recommend.

Appears to be well made