ASENEK LED Strip Connector and Mount Bracket, 5050 RGB Strip Light Connector, L Shape Solderless Snap Down 4 Conductor LED RGB Connector for Right Angle Corner, Gapless Connector, One-side Fixing Clip

I bought this for an existing LED strip that I have which works perfectly fine with another controller with all of its colors working totally fine. However, with this remote control and controller, it just lights up in red. If I press blue it just switches off and if I press green the green LEDs on the strip light up really faint that you have to squint your eyes to see if it really turned on. Also, the remote just has not power supply and without the power supply it cannot and will not work. I had to go to Frys and buy a 12v power supply. I dont even know whether it needs 0.5amp current or 1amp or 2amp or 5amp. I just bought a o.5amp supply, only to find out that it still does not work well. Or works only with red color. Other functions like flashing, fading etc worked, but again, only in red color.The connectors they have included are also defective. I dint test all of them, but a few of them did not work at all. Maybe voltage line was broken or red line (the only working color) was broken.I also sent an email the the seller led factory 2009. But they have not bothered to reply to my email even after one day.Now here I am, with my LED strip cut into pieces and partially installed in kitchen because I trusted this product to work and now I have neither a full length LED strip nor a kitchen mood lighting working setup.

Almost all the connectors are defective. Only certain colors work when connected, if they decide to work. I endedup soldering them after all.

I purchased this for the T-shape and 90 degree adapters. None of them worked! The LEDs would not light up. I would get intermittent connections. Or the color from one side of the connection to the other would be different. The only reason I gave it 2 starts in stead of 0 stars is because the splitter works fantastic.

Connections don’t work well.

Exactly what I needed to finish my setup. Be sure to plan out your spacing for the mount brackets.

Had most of the parts I needed to backlight some stage pieces. Good buy for all you get.Would recommend to get you started with a project.

Absolute garbage! Spent over five hours massing with these connectors was easier to solder the connections.

Exactly what it says. Makes running 2pin led strip easy using the "L's" $ "T's". Easy to use.