Flashforge Adventurer 3 Series and Adventurer 4 Upgrade Hotend, 3D Printer Parts with 0.6mm 265°C Nozzle Assembly

Well made and suitable for the Adventurer 3 series of 3D printers. Very easy to change and worked without fault.

Bought for my Adventurer 3C 3D printer and works just as well as the original. Good to have as a spare in case of future disasters.

I purchased this 0.6mm hotend to use with the flashprint vase mode. I found that the 0.4 models were just a little too thin, with the 0.6 end they definitely have a lot more rigidness to them. Detail wise i haven't noticed and reduction on detail, but then i have not printed anything more intricate with this nozzle other than a few Christmas trees. Swapping over the nozzle on an Adventurer 3 was quick and easy - the only tip i would give it that the printer does not recognise the nozzle until a full power cycle of the machine is completed and then it worked just fine. Remember to change the nozzle settings in the software before you print!I hope that you found my review helpful.

First chance to use new extruded. Unboxed and found the head looks likes it’s covered in glue. Tried to print and it doesn’t work. Print quality is rubbish. Tested with old extruded and filament and printer works fine. Just outside of return date so it’ll end up in bin.

I ordered this to replace my ADV3 nozzle after a really bad blockage that just wouldn't clear.I'd not replaced the nozzle before but this fit in perfectly and I haven't had an issue with clogging or heating thus far.I'd definitely recommend this as a good replacement part.

Bought this after the original nozzle stopped heating. It's a direct plug in replacement so really easy to swap out. I installed, recalibrated in case it had a slightly different length, and it worked straight off with no problems.

Currently at 400 hours on this nozzle and (touch wood) I haven't seen a clog yet!

The nozzle is great. The picture is miss leading you don't get the white fan included. Also the delivery charge was very expensive.

Fácil y rápida instalación. Se configura en segundos desde la pantalla de la impresora. Sin duda un componente de calidad. Lo uso con materiales técnicos como abs y materiales con fibra de carbono. Excelentes resultados.

ho aggiornato quello della mia flash forge adv3 con questo, consigliatissimo

Har inte provat den ännu. Ser ut som original så det bör fungera utan problem. Snabb leverans.

Il ne s'agit pas de 3 buses mais d'une seule. Il faut lire Adventurer 3, buse et non Adventurer, 3 buseS. Je vais croire que c'est une erreur de traduction et non une escroquerie... Merci de corriger cette erreur au plus vite.

non ci sono recession nulla da dire è il suo pezzo a dok