Upgrade Replacement Parts Kit for Pit Boss and Traeger Pellet Grill Smoker, Include Auger Motor 2.0 RPM, Induction Fan, Igniter Hot Rod with Fuse, Fire Pot Accessories with Screws

Everything fits perfectly. Left everything exposed, hooked all the wiring up, plugged it in and ran it on smoke, 225 and high. The motors work as intended and simple to install. The heating element seemed quick and the auger speed was perfect. The ash catcher I bought separately and is a great addition as well.

My Pit Boss is around 4 years old. The fire-pot has been rusting out for a while and I knew I needed to replace that and bought this kit because eventually the other parts would need to be replaced. Good thing I did because smoke started coming out of my pellet hopper soon after receiving the parts kit. Not only was my fire-pot bad but the auger motor also gave out. I replaced everything in about an hour or so and now it's working like new.

Auger motor is quiet and works, fan is high speed which helps burning the pellets, the ignitor works well,

Steel fire pot is really nice and a much thicker and stronger metal than the original one. Replacement blower fan and auger motor are direct swap out and seems better quality than the original ones. Used on 3 year old Pit Boss KC Combo

The pieces were easy to install. You might as well start by taking the entire smoker apart. This "rebuild" fixed several of my issues. My only complaint is that the lighter stopped working after the 3rd use. I ordered a 2 pack, on Amazon, and the smoker is working great, now.

I changed the fire pot the igniter the other day and these parts fit good and worked well. I did not change the fan or the auger motor. I saved them as spare parts for when I do need them. I bought them a few months ago because I was having some issues I needed to fix. And it finally warmed up enough to change the parts I needed too.

Item quit after 2 uses!!Make sure you get the proper RPM rating on the auger drive to match your grill specifications. This one is listed as being 2 RPM, which matches many Pit Boss pellet grills.Installation was straight forward. Once the drive assembly has been removed from the auger, you may have to use large pliers or channel.-locks to “unscrew” the auger out of the feed tube if it has become bound up with pellets.The kit comes with new fasteners for the burn pot. To remove the burn pot, remove the old screws/bolts and gently shift the pot off of the feed tube… away from the pellet feed tube. Once removed from the feed tube, turn the pot about 1/4 turn left or right to clear the igniter. Tilt and rotate the burn pot to remove it from the opening. Remove the screw that secures the igniter to the burn pot, making note of the depth the igniter was placed in the original pot. Tie string to the plug before removing the whole pot/igniter assembly. Use the string to attach and pull the new igniter back through. Put the new igniter into place in the burn pot. Place the burn pot turned 1/4 turn left into the opening and then re-align the feed tube. Secure the burn pot with the included fasteners. Put the auger assembly back into place. Test the assembled grill. Note: You will have to prime the grill feed tube quite a lot depending on your grill model it will take some time.***Update: Drive motor stopped after two uses!!***Buyer Beware!! After less than 1 year with only two uses, the drive motor stopped feeding pellets! I recommend that you do NOT but this item!

Worked like a charm