CSOOM 45 °Degree Chamfer Router Bits 4pcs, 1/4 Inch Shank, Adopt K10 Carbide.Use for Angled Edges, Laminate, Particle Board, Plywood Compact Panel, and etc by CSOOM

I use the bits to make roundover on table tops and legs. They make a very smooth cut and you can move quickly. They don't bog down.

The 1/4 inch shank makes these bits compatible with my favorite router, and the convenience is unmatched. It's like having a versatile set that fits seamlessly into my woodworking routine. The C3 carbide construction means these bits stay sharp and reliable, project after project.

I only use a router once in a while and these 1/4" shank bits work very well. Just using them on some pine and fir to put a 45 degree chamfer on the edge. They are sharp and cut well, just make sure the speed on your router is up, don't try to take off too much at a time and move the router in the right direction. A couple of light passes, increasingly deeper, will yield cleaner results. Very nice little set kept neat in a little case so you don't lose your bits. Very economical set but don't expect miracles if you are a power user.

These router bits have been a great purchase. The 1/4 inch shank fits perfectly in my handheld router and these bits deliver clean and smooth round edges on the materials I've used them on.

I tried the largest of these on both pine and a pallet wood harder than oak. In both cases the cuts were easy smooth and equal in quality to bits costing much more. You can judge for yourself in the attached pic. Funny story though about this review. I was presented with an option to review “Easy to remove”. I didn’t rate that. But if they meant from the plastic case it came in I would have given that rating a 1! I had to pound the bit out from the plastic case it came in! But these appear to be better than average sharpness for the price they are being sold at.

I'm still learning my router and wanted some inexpensive chamfer bits to learn. These fit the bill and I expect they'll last for quite a while. They seem to work well enough for me!

This is an excellent set of 45 degree chamfer router bits. This 4 piece set comes in a plastic case and feature carbide edges and ball bearing guides. The shanks are 1/4" and the quality is very good and the bits are very sharp. I give these bits 5 stars for quality and value.

Today I'm reviewing this 4 pack of round-over router bits,These are meant for wood and come in the 1/4-inch shank. I was able to easily process several wood species with these bits. I had no issues with dense white oak and the round over didn't cause any blow out for me.I feel these are a good value for the money and at least while new they cut well. I cannot speak to longevity of the bits just yet as I've only run about 30 linear feet through any individual bit.I am rating this set of round-over bits five out of five stars.Pros- Standard router bit- No problem with white oakCons- A bit of a pain to remove from holder

I was hopeful that these would be a good product vs value however when I looked at the set the smallest bit’s carbide was already chipped. How does that even pass quality control. On top of that it’s not like the bits could have banged together in shipping as they were very difficult to remove from the holder. It’s like the protective oil they use solidified and caused the bit to be stuck in the holder. Overall can’t recommend purchasing this set.