iRobot Roomba Authentic Replacement Parts - e, i, & j Series Replacement Dual Multi-Surface Rubber Brushes,Green

Buy the IRobot brand!!! I tried another brand which resulted in short runs and error messages, no pickup and a lot of aggravation. Product information on the off-brand indicated the brushes would fit and work with my model. NOPE, won't make that mistake again!!

Great, OEM product

I’ve ordered many roller extractors, even from irobot site and they were the cheaper rollers. When I opened this box, I saw the original design on the roller and knew these were the original rollers. There is no gap between the rollers, and they fit easily into place. I was so disappointed, paying full price on irobot website and got the same quality rollers as knock off brands. The originals last well over a year and didn’t rub away or break away. My last one didn't last 5 months (3x a week) and the lighter green was smooth. The darker green had pieces chipped away and hair cutting into the plastic and of course a gap between the extractors. I am ordering some more, before these disappear. And for half price, it makes it even better.

I used to purchase the unbranded version and I found out those were wearing and tearing far more easily, especially with all the hair and fur the roomba picks. I went back to purchasing the OEM version because the hair doesn't tangle and rip them the same way. They're a little spendier, but I find the cost difference makes up for the quality.

great product and works perfect. reason for the 4 stars and because of the cost. I have bought 3rd party brands that work just as well. if you want to keep the parts authentic, buy this. if you dont care about it being authentic and still get a good clean, try a 3rd party.

I have two i7+ Roombas with docks. For the past year, I have had third-party rollers installed in them, and for the past 8 or 9 months, I have had issues with them not finding their way back to the dock about 50% of the time. When one got something stuck in it's roller, I pulled the roller out--which was surprisingly difficult. The third-party rollers had corrosion on one side where it attaches to the Roomba, and had partially fused itself. I forced it out, and cleaned up the Roomba with some 91% alcohol.I then went upstairs to inspect the other i7, and found that it also had the same corrosion, but not to the same degree. I immediately bought two new sets of official rollers. Since replacing the rollers with the real deal, I can say that I have had no issues with the i7s returning to their docks.TL;DR: cheap rollers can get damaged easily and affect their ability to navigate to their docks.

Definitely use these in your irobot , used a knockoff brand and they didn't work these work great!

I bought one of the many many knock offs for these parts and they absolutely suck. They are loud, they don’t clean nearly as well. I don’t know what it is about the genuine rollers or what kind of special plastic emotion I robot uses but you really do need to use genuine replacements for the rollers. I have found that all the other parts are fine as knock offs like the filters, and the edge sweeping brushes. But the rollers are critical and they really should be the originals. As soon as I replaced them, the quality of the vacuum got way higher you can just tell by looking at it and the amount of dust that was captured.