GamesPower Kinect Camera Clip - XB782 (Xbox One)

A very nice and simple Kinect 2.0 clip to hold the camera/controller above your tv. The Kinect 2 snaps onto the top fitting and holds it in place, tightly. The unit's build quality is nice, i.e. doesn't feel cheap. The mounting system works well, but can be toppled forward if unbalanced. However, since most TVs won't be tilted downward on a regular basis, this shouldn't be a problem for most. In fact, the only reason I have mentioned this issue is because, I tried this mount on my gaming monitor which, does tilt downward. I thought it best to let people know that it may be an issue for some, if the mount is used in this way.Overall, a very nice Kinect 2 mount that should work well for most, if not all, tv set-ups.

Got this as I was fed up of trying to work out where best to have the Kinect. Now nice and tidy the the Kinect cable is plenty long enough so I can keep the Xbox one away to the side where I want it.

Its ok but my kinect doesnt clip on properly so have to be careful not to bump it. Will be getting a different 1

Brilliant, fits perfectly on top of tv

Works brilliantly with flat-screen TV. Solves the problem of where and how to put the Kinect device.

Very easy to set up done in seconds. This is very padded so no damage to the television.( I am using a Hitachi 40" ) This came very quick in the post and good quality. I cannot fault it. After you have set it up you will have to calibrate the Xbox one kinetic.

Does the job.

I bought this Kinect mount as a replacement for my last one which broke when I needed to adjust it. I bought this one because it doesn’t have parts that need to be twisted to achieve the best placement for the Kinect sensor. On this mount you just need to pull the back out to the right point so the Kinect sensor is in the right place and can see what it needs to see, it also has a small slightly ruberised foot so it does not scratch the back of your TV. The main thing I like about this mount is the fact it locks the sensor to it by going through the middle of the sensors stand and has two little points that push out against the base and holds it in place, my last mount did not have that feature.