Auto Vehicle Exhaust System Sealant, Non-Slumping Professional Repair Crack Adhesive Super Glue Sealer for Car Mufflers, Tailpipes, Catalytic Converters (Tube, Gram, 75)

The pipe welded to the resonator on my 08 pilot was broken completely off before the catalytic converter and a couple months back the flange after the catalytic converter was broken too due to rust. I inserted a pipe between the resonator and converter and used a couple of flange repair kits on the other side. I used this product to patch the seams between the two spots and car has been the quite for some time. Other products I used would become brittle and break off where this product isn’t doing that. Product was easy to use and was quick drying compared to others I have used. I don’t think this would work for large holes seeing that it is watery out of tube but filling in cracks or small holes this would hold up.

Used on my muffler leaks . Works great

It says it hold up to a really high temp . But the tail pipe never gets close to its advertised temp that it can withstand . Well after 3 days it disintegrated . Turned to dust probably at the highest temp of 250-300 f

First off, NONE of these exhaust band aids work on their own. Especially with a large hole, they just get blown out. Now I had the pipe just after a cat rot off, wanted a quick fix for a few weeks until I could replace Y-pipe, so bought some of this stuff, had some left over exhaust wrap from a motorcycle, wetted that down, smeared this stuff into it real well, then wrapped the pipe, a few inches on either side of the break, locking the loose end down with a hose clamp. Then took rest of tube and smeared it around the outside, let it dry naturally for half a day, then hit it with a heat gun until it turned light gray. Next day turned on Jeep and let it sit for 15 minutes before driving away. Just replaced the Y pipe a week ago, this stuff was still there in the way I set it up, hard as a rock "infused" into that exhaust wrap, for approximately 2 months. It did crumble as soon as I hit it hard, but up until then was rock solid and barely leaking.

Thus product does crack

The product performed perfectly for my repair

Worked perfectly and good quality.

Used it to seal the exhaust on a portable diesel heater just in case. Works well.

So I used this to get hopefully another year out of a rusty kia. The manifold and cat. are one piece and loke 500 bucks, ain't going that route. So I followed the instructions, the first time. I had negative effects getting the area wet as suggested, that made the tack up time go from the suggested 2 hours up to about 32( sitting in the shade with no wind) So the first time I started it it blew all the glue out because it was still wet. So I let it warm up. That set some of the stuff, and it turns out like a jb weld type of thing. So now after adding more for the 3rd time, I think I have it all covered and waiting for the last layer to dry up and do a road trip tomorrow to really set it in its place. I will come back with pictures in a few weeks to see how it holds up to daily use. But so far... it filled a bunch of holes, and is holding. So so far we're at a 5 star. See you in 30 days.

It works

So far so good

Colmatage catalyseur

J’ai réparé quelques petits trou dans mon silencieux et c’est parfait