Button Switch Rocker Switch Toggle Switch Self Reset Six Pin Three Position UP/Down Prewired Power Transfer Switch with Mounting Plate,Waterproof Cap.

Easy to use, solid.One improvement would be to have another plate on the back that screws tighten into and it hold the switch body.I replaced a very old switch and the hole was bigger than this new one, I used friction pressure against one side to hold it still.

No fear of battery going dead with a Meyer snow plow down in an bad situation and have to bring it home in the down position, or unhooking and leave it in a indescribable area for safety or theft concerns.Doesn't take a rocket scientist to install it. Basic electrical and common sense makes it easy. They even have instructions and pre-wire leaving power and motor to hook up. You still can use remote, when outside the vehicle. For making adjustments and hard wire control inside the vehicle.Now fear of losing the remote and being helpless lift and lower by hand, if you have someone with you.And some said it couldn't be done. Only cost a few dollars and some time and labor.Get on for your plow or other needs.

First off, this is a very industrial switch and I really like the quality of it, but it did not exactly suit my purposes and I had to modify it. An important thing to realize with this is the pre done wiring is not done with slip off connectors, they are soldered and covered with shrink tubing. In my first picture you can see I had to cut off the wiring, and then melt the soldered wires away to expose the prong connectors as seen in my second picture. The reason I needed this switch was because I swapped throttles on an older boat and the old throttle had the trim switch built in, so I needed a replacement. With this particular aftermarket CMC power tilt and trim unit, it has a set of relays that control it and all you need to do is make contact between purple (live power) and green to go up, and blue to go down, so essentially I just needed the positive connections with no ground. As you can see in the third pic, you place the live power (purple) in the middle and when you flip the switch down, it makes contact with the blue, and when you flip up, it makes contact with the green. You only need terminals 4, 5, and 6 to do this. As a last note, this older boat had a wooden dash, so be aware you may have to chisel out if you are placing the switch in something relatively thick. Overall a great purchase but I wish it would have clearly stated the wires were pre-soldered on which made it a pain to modify, and in addition there was no guide on how to actually wire the thing which was very annoying.

Used it to replace the switch on my table sawWorked great and was easy to install

Exactly what I expected from description!

This is straight up dangerous advertising a 120v 20amp switch pre-wired with 18 gauge wire rated for 1 Amp. Won’t at all work for the application I bought it for (unless I want to burn my RV down)

It works great did the job

easy to install and easy to mount. I now do not have to worry about bumping the winch/snowblade switch on my side by side

Switch was turned on and off 4 times. Now the contacts are stuck in the on position and it won't turn off. Only switching about 0.5-1 amp load. Didn't last a week.

Bought this for my trailer knowing that is water proof but is not has butplugs on the back which is exposed to elements and water will get to it