HG Power 4 Inch Soffit Vent, Adjustable Air Vent Cover, ABS Round Ceiling Vent Covers for Living Room, Attic, Bathroom, Kitchen, Ventilation Use, White - Opening Size 3.59", 2 Pack

Replaced 50 yr old vents. These are easy to install, easy to operate, and are much quieter than the previous vents.

So much better than what I had and easy to install

This seems like a fairly well designed plastic vent. We are using it at the end of a bathroom exhaust vent. There are louvers that can be adjusted to decrease of the flow through the vent. Since we are using this as an exhaust vent, we didn't need them and they were easy to remove. The outer white vent cover clips on to a a dark grey housing which extends a couple of inches into the vent with clips (4" in our case). Since our vent was bending just above where we installed this, we removed the extension and caulked the connection to make a seal. The outer vent cover snaps securely to the inner mounting which attaches to a flat surface with 4 provided screws. The product comes with illustrated instructions, but they are only written in Chinese. So you have to go by the pictures. Thankfully, it doesn't take a rocket scientist to figure out how to install a vent cover. I would not recommend this for a heating vent if you want to be able to periodically change the flow level through the vent to increase or decrease the heat or cooling. There is no easy way to change the flow other than removing the vent cover and adjusting the louvers and then reattaching the cover. Not a convenient solution if that is what is needed.

I placed a screw on the inside. I predrilled a hole through the dark plastic and into the metal vent hole. I noticed if you don’t do this and closed the vent, the air can loosen the hold of the cover and drop out. There were no screws that came with the vent so you’ll need to get some. They really look better than the metal ones that get rusty over time. Adding that extra screw on the inside really makes this perfect. I showed the difference in two photos of how not having that extra screw in starts blowing the vent out. The flushed vent is with the screw and air blowing. Hope this helps.

These are nice looking upgrades to the old metal ones and easy enough to install. Biggest issue we have is that the inner and outer vent ring just slip inside one another and when the heat is on it causes the outer ring and cover to fall out.

Terrible quality and design the whole vent just falls out from the ceiling with the housing screwed in still the only way you put the vent part up is by shoving it inside the housing and overtime when air comes on it eventually just falls out.

Use the box to make a circle by drawing around the black part for your template. Fit well. I use it for my dehumidifier during high rain cycles and pair it with a humidity controller

Snaps right in and find hold it in place. No need for screws. Looks good and isn’t heavy enough to bend tiles. Will have to use mastic tape because it’s a little smaller than 6” duct but a large zip strap and some tape works fine.

Vent are easy to use and fit nicely

Cheap build.Louvers on it close or open on there own, feels cheap but gets the job done for what it’s intended/Restricts air flow slightly. Air flow without cover 10/10. Air flow with cover about a 6/10.

Work great.

Good product. Fit well.

I installed four of these. Two for smaller vents and two for larger ones. Performance is garbage. They are falling out of the ceilings. I had to completely remove all four and install Home Depot ones (more expensive). The ones from Home Depot are working perfectly compared to these garbage ones (they are in the landfill now because they are useless).