10-Pack UL Listed LH0482 Non SHUNTED T8 SNAP-in BJB 26.422.1009.50/26.422.4009.50 Rotary BI-PIN with Rear Split PINS

Used these to covert a 4x48 T8 bulb fixture to LED T8's. Replaced stunted holders with these. Removed and tossed ballast. Wired up and done. Took about 15 minutes. Note that my old lamp holders had the tension spring on the back. These new ones don't come with that but you can re-use the old ones. However the fit is good enough that I only used them at one end and probably could have left them off all together. Sockets have a very precise click when the bulb is locked in place. Would buy again. Amazon was the only place I could find this style holder.

I only needed four tombstones for the light fixture I was converting but these worked perfectly and now I have extra for the next one. Extremely easy to wire up and I now have LED tub lights in place of fluorescent. They have been running without issue for a month now.

I have an odd type of kitchen light using the smaller T8 bulbs and the stores had nothing that worked. These snapped in quick and easy, the bulbs slid right in and locked with little effort, and everything works as advertised! Would defiantly buy again. Thank you!

Worked fine for my purpose

what i needed to convert to led for my fixture

Direct replacement. Perfect fit

ok

Worked perfect for my light.