12 PCS DTF Printer Damper, Small Ink Damper for DX5 L1300 L801 L805 L810 L850 L800 L1800 Printer

Our ProColored brand A3 L1800 DTF printer (the one with the panda face on the lid that's also sold under other brands and all over direct-from-China websites) came with dampers that were super fragile and difficult to get a grip on without squeezing them in places they shouldn't be squeezed, so after several months of taking the white dampers on and off to syphon air bubbles out, they started to leak. These are MUCH easier to handle, and much smaller overall. I still get white pigment settling after 12 hours or so, and still get bubbles in the lines, but these don't seem to get bubbles in the dampers the way the factory ones did. They also show no signs of damage after a few months, which is great.I have one very minor complaint, which could easily be my printer manufacturer's fault as much as mine, but the way these are retained towards the front (film exiting) edge of the printer doesn't exactly match the carriage in mine - they have two little tabs that go around a tab in the carriage, and while my printer has six print heads, it only has five of those tabs. The left five dampers are all secured as appears to be intended, but the rightmost sits at a slight angle and is kind of wedged in there.That said, it's working fine and isn't leaking at all, and there's no reason to remove any of the CMYK dampers until I eventually replace them all and all the lines.

I used this on my Epson DTF printer to replace the original and because the dampers are smaller theyactually work better and less clogs.I would buy again

ESTOS damper no detienen la presión de la tinta son Huecos de donde se montan Al cabezal, así que cuando esta en descanso la maquina baja la tinta hacia el reposo del cabazal y sube la tinta mezclada a cualquier línea del damper