Frassie 29 inch Under Desk Pull-Out Drawer Black Office Storage Organize Mounted Sliding Metal Drawer

Product seems to be good quality - sturdy metal drawers. The provided screws are a little short. Only gave 4 starts because of inaccurate product description. Fortunately will work for my needs regardless but the actual drawer dimension isn't 17.9" wide as advertised. Actual dimensions are as follows:ACTUAL (OUTSIDE) DIMS:15.75" WIDTH x 10.75" DEPTH x 2.375" TALL.The drawer itself is a hair smaller at about 13" interior width x 9.75" depth.Other than that it seems to be a good product. Will update this review if it proves otherwise.

The first drawer I received, I noticed that the left side sat lower than the right. The second drawer I received exhibited the same exact height mismatch issues as the first. Could I have just gotten two defective drawers back to back? It's possible. Do I want to go for a third attempt? I'm not quite sure.Aside from what Vivo offers, there aren't many offerings for a drawer that have a depth less than 13" and a width greater than 25". Unlike the competing Vivo drawer, this one is a single piece all metal design.There are cut outs in the back of the drawer that allow you to run small cables that would allow you to charge devices like a phone or a keyboard. Opening/closing the drawer is par for the course for what one would expect from a drawer. The mounting hardware consists of 4 screws and plastic washers, but not template to use to pre drill holes. Fortunately, I have a sit stand desk and so I just pinned the drawer in between the desk and my stool to hold it in place and drill the pilot holes.For $80, I can look past the cheap plastic washers that are included and the absence of a drill template, but the uneven height (about 4~5mm) not so much. Unfortunately, as I mentioned earlier, there are not a lot of alternatives and I don't feel like I'm getting my money's worth. In other words, this and similar drawers are way over priced. Unless you can look past the height mismatch, I'd recommend a hard pass on this drawer.

It holds stuff too.

Installed on my custom desk. Seemed to fit well. Used off and on for a month and a half. Tonight I go to grab something from inside and hear a clunk on the floor. The bearings in the drawer slides somehow came out on a little strip. I pulled the drawer out and pushed the bearing slide back in but only a matter of time until it comes out again. That should not happen on an $80 drawer. Very frustrating.

The product was not the advertised size. The listing stated 17.7 " but mine was 15.7 " so what I intended on storing would not fit, need to return now.