Faucet KF 80001 Single Handle Pull-Down Kitchen Faucet, Brushed nickle

Don't know what the fuss is all about. This faucet really exceeds my expectations. My major concern was leaking. This has no leaking at all. I think the trick is to use Teflon tape for all thread connections and connect all hoses before mounting the faucet.Yes, a couple of minor issues..- No hot/cold marking on faucet water lines (NOT talking about missing Blue/Red on on/off handle). I had to connect water supply line and tested it before installation and found out short vale was for hot water. No hot/cold indication on on/off handle. But I think everybody is used to hot water (red) on the left and cold water (blue) on the right- Faucet pulldown weight locking plastic tab can break easily. Wrap around the weight with duct tape or some kind of tape if it breaks. Just bad design. They really should replace plastic tab with screws to lock the weight like others pulldown faucets I've seen.Tips from my experience.. - Use Teflon tape for all thread connections - Install all hose connections before mounting the faucet. Faucet connector hoses for hot water and cold water and pulldown sprayer hose. Yes, it is a bit tight to put the large mounting washers and lock nut. But it is way easier to tighten connectors before mounting.- Get individual stainless steel finish sink hole covers instead of a deck plate if you need to cover holes from 2 handle faucet. These individual hole covers are rounded shape and low profile and much easier to wipe out standing water and look much better than deck plate.- Inclued supply lines are about 24 inches long. It they are too short for you you can go to HomeDepot or Lowes near you and get a supply line with 3/8 male end and use it as extension. You need to look for it. Ask the person who works in plumbing department if you can't find it. Or you can get a longer supply line with M10 male end on Amazon. There are plenty on Amazon. I think M10 connectors are used in Europe, Asia and everywhere else. That is not a problem at all.- Faucet might feels a bit wobble on a thin stainless steel sink. That's NOT the issue with the faucet. It is because the sink is thin and flexes. Deck plate or stabilization plate under the sink might help. That does not bothers me.

I really like this faucet, this is a very good quality for this price. It looks great and the shipping was super fast.

Licensed, experienced plumber installed faucet. Leaked at pull-out sprayer. Plumber couldn't provide solution. 2nd faucet ordered(also returned for same reason). Poor directions. You get what you pay for.

The only aspect that is a problem comes with connection of the retractable hose. To get a completely leak-proof connection in existing sinks requires a special open-ended box flex head wrench to allow tightening with an obstacle such as a sink and back wall restriction to motion of a normal wrench. In new installations this wouldn’t be a problem if the faucet went in before the sink.

Oh my! When I bought this Faucet, I was hoping that it wasn't junk because of the low price. My Faucet is leaking and I'm short on $....... I was dumbfounded (in a good way!) because I never dreamed it would be such good quality or as beautiful as it really is! Thank You so much! I am absolutely delighted!

This is a beautiful faucet but its not meant for US plumbing. It is metric. You will have to do some adapting with metric plumbing parts not sold in most stores.

Less expensive than going to the home improvement store. This faucet is very nice!

Very nice looking faucet easy install will buy one for my home