DAYDOORRanger Tie Down Anchor, UTV Lock and Ride Compatible with Polaris Ranger 1000 XP 900 XP 800 700 500 570 General 1000 Polaris Accessories with 1-7/16" Hole (6 Pcs,Black)

I like that they are easy to put in and start using

Not a whole lot to write about these. Excellent value, easy to install, secure. Fit is good and tight. They make it so much easier to secure things in the bed of your SxS, wish I'd done this a long time ago!

These are nice, and they will work great. My only complaint (very minor) is even if you loosen them all the way it's very difficult to force/push them down into the holes far enough to get the metal top place flush with the side bed rail (and that's BEFORE you twist to tighten). There's enough "catch" to tie twine down and the second picture shows about the "MAX" you can force one of these down into the hole. Also, have a good piece of rope to pull them out if you plan to remove them because they will form a substantial vacuum.

They fit good and hold good. Seems like they will last awhile.

Too small for my Ranger 570

These are a great accessory for strapping things down in my Polaris Ranger. They fit nice and snug and hold fast when tightened down, I used a little dish soap on these so they would slide into the holds easier. The hardware is zinc and should hold up well!

I've been needing some of these all Summer! Finally got some & they fit and work. As some have mentioned, you twist turn (to the right) to tighten in. I didn't push them all the way in as I need to wash and clean my Polaris first & I was afraid I'd get them in there with all the dirt & not be able to get them out. So yes, they fit well. I'll be curious to see the durability of the metal. As it's exposed to the weather, misting rain, etc... will they rust? I will update if they do.

These Polaris bed anchors are pretty nice, and they get the job done. They go in fairly easy and just tighten right up by twisting the eye on top. We are going to use them to secure a homemade rack to the bed of the UTV to expand our storage and carrying capabilities. Until that project is ready, they are being used as intended as tie down points on the bed to secure loads.