CNC Tips and Techniques: A Reader for Programmers (Volume 1)
J**I
Messy but useful
This has quite a few good explanations of some of the more obscure G codes, especially relating to offsets and canned cycles. Being a reprint of magazine articles makes it somewhat disorganized, though there is a topic oriented table of contents. There is also some confusion about the various codes and formats used by various machines over the years. I found penty of good information to justify the price but had to read most of it twice to absorb everything. A bigger book or fewer topics would have made the whole thing more manageable.
J**F
Four Stars
there are a lot of usefull tidbits
S**N
wish it had more lathe canned cycles
fairly useful and informative
G**S
Four Stars
Amazing book!
B**N
Worthless
No illustrations for kindle. Not much useful tips. Not organized well on topics. Same info repeated from Peter smid's other books
C**D
Five Stars
Very helpful. Can't go wrong with Peter Smid
S**T
Five Stars
Good info.
K**M
Four Stars
Good book
S**H
no real good advice for some one starting out at CNC programming
Did not think this book was of much use, no real good advice for some one starting out at CNC programming.
R**A
Two Stars
VERY POOR PAPER AND PRINTING QUALITY
Trustpilot
2 months ago
2 weeks ago