Ubanner 120mm Case Fan Light,LED Silent Fan for Computer Cases,CPU Coolers (RGB, 2pcs 18 LEDs 30cm LED Strip,2pcs LED Fan, F Series)

I bought the product and installed it into my computer however I came across a couple of problems. I was given good customer service from the sellers and managed to get it working successfully. It looks great inside my PC and It is also brilliant for the price so I recommend it.

Perfect and reallt happy with the product! But i dont knwo how to adjust the speed as its a bit loud... I think they are set on full boost at the minute so need to try work out how to set them up.. I recommend this product! I leave the power supply off so its just the lights on:)))

Its a nice stuff for the price , but the cable from led strips is a bit to short for me ,and i dont like conection beatwen fans to 3 pin header . i use mini matx case but if some one use atx or bigger case gonna struggle with short cables. sometimes wings from fans tutch diods on led strip inside the fan and makes some big noise, try to do better versions of fans or maybe stick led strip to the plastic around fans . Lighting its bright and nice, got 4 modes a lot of nice colour i recomend this product for all beginer pc builders

Rgb is great in this kit,a bit more noisy than my phantex case fans but is offset with a bit more air push on the same setting.The strips are good too but very limited on where to fit because they are short...but once is done is great.Unfortunately for me one of the fans has a crackling,friction noise that is becoming unbearable so im going to disconect......

Pros Very easy to install and use. Clear colour and brightness. Fans are better than the RGB ones I got with my case.Cons the connection for the doubler are a 3 pin to a 2 pin (for the power) so you have to make sure they are connected properly. Need to make sure you have a bit of room for the small box that controls the power and RGB.

Read loads of reviews about this product and was still a little skeptical, however once I installed it, it actually looks pretty damn impressive.:) was quite easy to fit and connect.

This is the second UBanner product I have purchased and I cannot fault it. Great price and an easy way to add some cooling and RGB to your build. Even comes with a remote pad to control the RGB. The Fans can be plugged into a 4 pin fan header using the supplied splitter so PWM control works to vary the speed. Soft Rubberised mounting points eliminate the possibility of vibration. Highly recommended for the price.

I installed these to spice up my very old Antec LanBoy case and they look great, however, at low speed the fans make a sort of buzzing/vibration noise. If I crank the fans up in speed, this buzzing noise goes away but then I have slightly louder air flow noise. It is a bit annoying I can't run them at low speeds, but then I don't notice when I'm gaming etc anyway. Great air flow which has dropped temps all round, and they look great with the LED strips top and bottom of my case!