XINYIELEWaterproof Outdoor Project ABS Plastic Junction Box IP67 Weatherproof Dustproof Enclosure with Hinged Cover, Mounting Plate,Wall Brackets for Power Project (Grey,19.7"x15.7"x7.9")

This product was the ideal size for the electrical enclosure on my traffic light project for my Man Cave.

Initially, I was going to return this product because its measurement did not match my anticipated installation. Then I realized that they have different pictures with different measurements. Make sure to look at the one that shows the internal size, not the size mentioned in the description (as that's the overall dimensions). But that's my fault.The box seems sturdy. Wish it had a way to use a lock to keep the door from being opened. You could use a zip-tie though if needed.Not sure what the mash back is good for or how to best utilize it. There aren't any "break out" points to feed wire, and use the supplied wire-seal-plug-thingies. As others said, it comes to you as watertight as it gets, so like everyone else nowadays, they aren't lying...but once you use it as intended, you'll be responsible to keep it as watertight as you can...

Very weather proof if you do a good job with making holes for the connectors.Love that it's transparent so you can see inside. Good size for multiple project uses.

The overall quality looks great. This is a nice sturdy ABS enclosure with a good seal, but ended up being smaller than expected so check the chart. The width and height claimed is the overall size of the lid without the hinges or latches. Inside usable space is nearly an inch smaller, just so you know. Fortunately, the chart on the description page shows all dimensions.I’m building a control system for a 2 container mushroom grow operation and need good enclosures. This small one will likely be great for housing the light and fan control relays. I need a considerably larger one for the Raspberry Pi, display, and power supply, sensor outputs, etc. There’s a good chance I’ll stay with this unpronounceable brand with the obnoxious large logo where I would put the display for the larger box, but I see the size I want will also be about 2” deeper, which I really don’t need.

This is a heavy, well-built enclosure for electrical/electronic projects. It is waterproof, airtight, with no intrusions - no holes, except for the cover, which has a gasket and metal closures for a tight seal.It comes with cable glands, but you'll have to drill your own holes (I consider this a positive). It also comes with "ears" that will screw onto the back, and protrude to the sides, so that the box can be attached to a wall, etc., and it comes with a PCB mount grid pre-installed.My sold complaint - the manufacturer had to slap their logo on the clear lid ... which is not helpful; it's on the plastic ... not just the packaging. It reduces the "clear" area, in the event you are using solar panels, or photodiodes, or similar. It also just looks bad.