Custom Branding Iron for Wood - Custom Branding Iron for Wood Leather Meat Perfect for Weddings and Handcraft Lover

Very well made, so thankful a friend suggested this item. Makes things so much easier and looks very professional.

Love the stamp but I do not like the handle. It does not stay screwed in tight which makes it hard to get the stamp even.

This brand is totally worth the money for a small time crafter such as myself. The image is clear and doesn't look like a burnt blob. That being said, I've seen unfair reviews where the brand was clearly applied too long. I've been trying to find a sweet spot and so far a 175°F brand held 4 seconds on leather seems to be working.There is a bit of a wait on this product but it's worth it!

Nice quality but instead of EST 2004 and it engraved 2024, so I have to order from another store for the correct one, left in the closet!

This was made and in the mail in less than 24 hours! FAST Shipped and in the mailbox 5 days after I placed the order. Quality brand with nice, sharp letters. The photo I attached was my 1st test piece. Found that best procedure was to have a piece of scrap that is the same species wood you plan on branding. Don't put any finish on the wood before you brand it. Heat the branding head until you think it's hot enough (count to 15 with head in a propane or Mapp gas torch flame). Then test it on your scrap wood. If it is too hot, the brand will look like my photo. Note that if you have some light charring around your brand like the attached photo, lightly sand the brand with 120 grit sandpaper and it will clean right up. Do another test brand without reheating the head and keep on branding your scrap until you have a crisp brand with little to no charring around your letters - then do your brand (do not reheat). You can get 2 to 4 good brands without reheating the head - that's following your test brands charring up the scrap. PRACTICE ON SCRAP until you get it right. Then and only then brand your finished product. I strongly endorse this product.

Imprints great. The shaft and tint nuts are pretty flimsy. I bent the rod handle after a few uses and had to put it in the vise to get it straight again.

This works great

nice piece for my wood working shop lets me put my brand out there for potential new buyers of my crafts