(45m Green Rotary Replacement Line Clothes/Washing Line 150ft

Good cord with degree of flex that steel cored wires don’t. Used to tie together frame for netting around vege garden. Ideal!

I needed to do something about my ten year old rotary clothes drier - the existing line was cracked, snapped in several places, and was leaving dirty marks on the washing - so after pondering the relative merits of steel-cored versus nylon cored, I plumped for this one on the basis that I thought that it would be easier to thread through and knot the original featured 'crimps'). It being a very large rotary airer, I needed two packs of the Everlasto product. It arrived very quickly - within 24 hours of ordering - and although threading it through the myriad holes (if you're tackling the job, don't try and do it all in one length - much easier to adjust and tie-off if you only do a couple of rows at a time...) took just over an hour (and it's worth remembering that if you keep the line in its bag it doesn't get tangled as you pull it out to thread through) it was time well-spent as the washing line is now back up and running and drying! Seems to be an excellent product. Flexible enough to thread relatively easily, and knot where needed; doesn't seem to stretch unduly even when fully loaded; nice green colour; excellent value for money; she who must be obeyed is very pleased with it. So all in all, I'd thoroughly recommend!

Just got to find someone to fix it to my rotary washing line

Purchased for use with an old unbranded dryer where the old line was literally disintegrating.Had no idea what length would be required, and found that this line was just sufficient: there were a few unused holes at the end of the arms and I suppose that a perfect job would have meant having a replacement line long enough to use these holes too. That might have meant 180 or even 200 feet - the distances between the ends of the dryer arms are considerable.I spend ages reading the review of others trying to work out how best to fit the new line. We have a garden table with a hole in the centre for a parasol; I inverted the dryer and put the top in the hole....so that I was doing the re-threading at waist height. I also started around the middle in the belief that it might be quicker to thread half the line through half the holes (twice). Perhaps a mathematician could advise? Finally I looped the line around one of the four arms on each circuit in the hope that the tension would remain constant during subsequent use. There have been no complaints although (now that I have asked in order to complete this review) I understand that the tension could be increased a little

Easy enough to re-fit to our rotary line and appears reasonable quality. Although I estimated it would need to be approx 40 m long for our average size rotary line, the 45 m length was not quite long enough for the full 10 drying line circuits. A lot easier than replacing the whole rotary airer - concreted into the garden!

Perfect. I have a 4 way rotary. Not quite enough to fill it all BUT never used the 2 inner ones anyway. I knew this before I bought it.These are not as easy to fit as you would think as the 4 bars can move and you get 2 wide and 2 narrow so ...The tip is to make sure the rotary is set up correctly angled. Start at the outside and loop around each corner. CHECK before you continue to make sure it is square (or equal if a 3 way). Once the outside is done and equal,it is a simple matter to wind around the rest.I have only given 4 stars as it would have been an idea to see a tip on this. Otherwise it was perfect. 4.9 stars would be more appropriate !!!

This line is only half as thick as the original washing line I am replacing. I will be looking for a different brand as this is not suitable

Replacement rotary line