Wireless HDMI- One Transmitter and Three Receivers- G9R Extender Kit, Wirelessly Simultaneous Expansion, 50M/165FT @60Hz, 5.8G/2.4G Plug and Play- Stream Video from Laptop to Multi-TVs/Monitors

Simple setup and use. Good for our conference room with multiple TVs.

This is my third attempt at setting up a wireless HDMI system at home. I am reverting to the second system (BRAIDOL) I purchased a month and a half ago (which replaced a less successful system from TPUFO). I really wanted/needed the 1 Tx to 3 Rx functionality of this (YAOMAISI) system, and was willing to pay up for it, but was not happy with the result.It installed quite easily, but the initial video quality was poorer than the 1 Tx to 1 Rx of the BRAIDOL system I had been using. It got worse when I tried running multiple Rx units simultaneously. Figured I would sleep on it and then try and tune/tweak it the next day, but after that initial success I was never able to get any of it to work again. Written instruction are limited/poor.Wireless HDMI is apparently harder than you might think, and I will muddle through with my BRAIDOL solution for now and see if the next year brings any sort of improvements in this technology.

I bought this to run 3 TVs in a restaurant, most receivers were with in 10-25 feet from the transmitter and they would constantly drop out or lag significantly. They may work for the first 10 minutes or so, but after that they start to lag and disconnect. Just save up and buy something higher end