Stainless 2.5" 90° Mandrel Bend Elbow - 1D/2.5" CLR Tight Radius - 16GA/.065" Wall - 2" Leg - SS304 - Stainless Bros

This 90 was perfect for my 2” fresh air vent on my pellet stove.

Great

These 5” 45 degree elbows are super high quality. Unfortunately I ordered the tight radius 5” 90 degree elbows so these won’t work and I’ll be shipping them back to hopefully get the correct parts

A great replacement for water line on engines

All good. Thank you.

Great part, I will buy more.

This 1.5 Stainless elbow is better then expected. It is smooth and does Not have any burrs on it at all. It is sturdy and thick. I used it to make a sharp turn for gas fill.

I used this for some exhaust bends to to get out to the back of my project car; but you would be proud to have it in your engine compartment as part of a turbo installation. Photo shows the up and down curve over the leading edge of the lower rear suspension A arm where I used the right angle bend cut into two pieces and welded back together.