SECUROAD Super Bright Solar Lights Outdoor IP65 Water Proof, Wireless Radar Motion Sensor Light, 4500mAh Aluminum Metal Housing Security Lights 4 Modes Flood Wall Lights, 1 Pack (Daylight)

Had purchased a bargain solar led motion light from a big box store. It worked but the light was very weak. Then I ordered this light. It is literally like night and day. This light is BRIGHT! It makes the previous light look like a toy. And this was actually less expensive. It looks like an OEM light fixture with its clean metallic appearance. It senses movement much further out than the typical IR sensor lights. And it really puts a useful amount of light in the area. HIGHLY Recommended.I'm updating this review because of someone else's answer to a question.There is no setup issues with these lights. Just select the MODE based on the instructions. Not like IR Motion Detector Lights, these are very sensitive for a much longer range.Dillon's comments to a question interested me since I have a completly different and positive opinion of these lights. I'll take them one-by-one... #1.. "High Dollar". These units cost about $36 on Amazon. You may find less expensive units on Amazon, but they don't have the features this one does. This uses Radar Detection instead of IR Detection. IR Sensors tend to burn out when mounted exposed to direct sunlight. I doubt these Radar sensors would. And the lowest cost unit at Home Depot is $40 and has about half the light output of this unit. I know because I bought and tried one and returned it. It also "looked" like an Add-On unit, unlike this one that looks clean and sleek and "built-in". #2... "Leaks, holds Water"... This concerned me, even though I live in a more desert climate. So, I took off the end caps with the 3 screws on each end and looked at it. Pictures are attached, You can see that the case is Extruded Aluminum and the end caps are high quality metal. There is a Silicon Seal where the cap meets the case. Looking inside, the ONLY holes where water might leak are the screw holes, but these are on the back of the unit that mounts against the wall. The Silicon Seal also seals against the Solar Panel. The fit of the solar panel in its mounting slots is very tight and leaves very, if any little space for water to enter. Besides, the Solar Panel slopes downwards, so any water on the surface would most likely flow off the light very quickly minimizing any chance water would enter the case. The ONLY holes in the case are to connect the interior electronics to the Solar Panel and the LED Panel. However, the LED Panel is on the Underside of the case so water would not flow UP into the case. Also, the LED Panel is attached very securely to the inside of the case and appears to have a very good seal. If this light fixture was under a waterfall or exposed to roof runoff, there is a slight possibility water might intrude, but that could easily be mitigated by placing Silicon Sealant on all the seams and screws.I HIGHLY recommend these lights.

Been looking for a LONG time for the Right security light for my patio, and stumbled upon this unit fortunately!- rugged aluminum case- metal mounting tabs on back- nice sized solar panel on top. No batteries. No complicated and expensive wiring.- WARM 3000K LED output option. Easier on the eyes at night IMO and matches our other exterior lighting. There is a 5000K daylight version as a separate product. The color temp is not selectable, so you just have to order the right version.- bright output lights up patio area evenly without hotspots- multiple modes. 2 button presses gets it turned on and set to light-up upon thermal detection, then off after 20 seconds. Other modes are Dim/Bright, Always On at Dark , and one other I think.- off while daylight condition exists.- no fiddling with detection sensitivity or light duration. The fixed-in-unit out-of-box experience just works. It really could not be any easier to setup.- detects my cat if close enough, and generally a good 25-30 ft detection range for people. But not so sensitive that every little thing sets it off. I had a downspout near the area I wanted to cover and while not specifically mentioned in the manual as a mounting method, I just used a long zip tie though the metal clips and around the back of the downspout. What's nice about mounting this way is I can easily adjust higher or lower, and no holes though siding. Every now any then a product comes along that exceeds expectations and this is one of them!

I bought this light for my shop (quonset style metal shed), so did not want to drill holes in the surface. I tried mounting with 3M 50lb double tape, removing the small mounting bracket on the back of the light, to have a flat surface. This actually worked for a few months, until the tape failed and it fell 12 feet to the ground. The light was ok and still works great. I ended up using the existing tiny mounting screws to attack two 5lb, 1.5" magnets. Should have done this to begin with. Much easier and is holding great.The light does have several settings, which is nice. Motion to turn on (off to High beam), Dim on always until motion to high beam, always on dim, and Off. My light sits about 12' off the ground and does provide good light. I t would have been great to be able to set how long the light stays on after activation.

Led lights, very bright and last over night. Sensor is great.

It is easy to install and has great coverage and light. They have been up for a year now with no issues. I had to replace the previous ones withing six months.

Stop looking for something else. This is the best buy you can do. I already ordered more than 10 different Led lights and I returned most of them. This is by far the strongest, brightest and it will be on the whole knight. I recommend it.

I have had 4 of these lights for 2 years and I have not been able to leave them activated.The case is well built, the solar panel seems high quality, and the light is bright.The bad, the motion sensor is so touchy (I would say faulty) that I can't leave any of the lights activated. They turn on and off constantly and eventually just wears the batteries down where they don't work the rest of the night. I want to like them, but the motion sensor makes them useless for someone like me who wants them off unless someone or something is in the yard. I had little $15 lights before that are no longer made that worked perfectly.

I thought I may have had damaged products but I let them soak up the sun for the day and held the little toggle button for 5 seconds. That left them on dim and when an intruder would appear they would brighten up. If you press the button for the second time the light will stay off and then turn on when an intruder appears. That was the best option for me as it works perfect now.

Product would only work well for about 1 to 2 hours then just didn't seem to really want to work well anymore. The motion detection was way too sensitive and after while it just stopped working. Took it down recharged it and reset it Worked for another 2 hours then stopped. Did this several times. Sent it back and got my money back.

100% recommend, works as advertised

Light intensity not as bright as I had hoped for, march 2020 the unit no longer works