Application Instruction:1.design picture on the computer ,reverse the pattern.2.feed the vinyl into your plotter or cutting machine. materlal will not require any speclal settings.3.Weed out the excess to reveal the pattern.4.place the graphic onto the target area.Make sure there are no wrinkles on the material.5.Heat an iron on medium setting Pre-heat your iron to 160℃, NO STEAM ,use the iron with medium pressure on the pattern to transfer it to the garment. press for 10-15 seconds over the entire pattern and remove the iron.6.After finishing the blanching, it will be placed for 8-10 minutes. After the pattern is completely cooled, the PET release film can be torn off.. If any part of the iron on vinyl lifts off, repeat the steps above until you can peel off the clear backing without lifting up the vinyl.Warm Tips1.Make sure there are no wrinkles on the material.2.It is recommended that when the clothes are completely cooled, the tear effect is best.3.If you are having trouble, try turning the shirt 90 degrees and pressing again, this should eliminate problems from cold spots.4.If you've already ruined one shirt, keep using it to experiment. Cut small pieces of heat transfer and try raising or lowering your temperature, or pressing longer or for less time.5. Please wait for at least 24 hours to wash your design.LAUNDERING* Hand wash inside out after 24 hours* Do not dry clean* Do not bleach* Warranty & 100% Satisfaction Guarantee: We are confident about our Heat Transfer Vinyl quality, Contact us if you have any problem with the Item, Within 24 hours response,We are always here to serve you!
Trustpilot
5 days ago
2 months ago
