PERLESMITH Speaker Stand Adjustable - Extend 20" to 44" - Holds Satellite Speakers & Small Bookshelf Speakers up to 9 lbs, Floor Stands Compatible with Sony Bose Polk JBL Yamaha and Others - 1 Pair

I purchased 4 of these speaker stands to hold the 4 (left and right front and rear) for Logitech Z906 Surround Sound system. Here's my personal review of several categories:Packaging, condition, shipping: 5/5The speaker stands were shipped 2 to a package in durable cardboard containers that are re-usable and re-closable using a front flap with insertion tabs. All materials were separated and packaged well in their own individual compartments. All screws/hardware were separated into pouches with letter codes to identify them (similar to assembled furniture). Everything was shipped correctly and packaged securely.Construction/Materials: 5/5I was extremely pleased and surprised. I was expecting thin and flimsy plastics and metals as with other products, but was very happy to find that the poles and base are thick heavy durable metals The stand sections are threaded on the ends and screw into the heavy/sturdy base. The base itself reminds me of a heavy cast-iron kitchen pan. Either rubber caps or threaded nails (both included) can be attached to the bottom depending on your needs. These bases are stable and will not tip over easily. They stand upright and level and are well-made. The extension pole on the top (used to change the height) is durable and comes apart easily when needed. Although screw-tension rods like this are not perfect, they work quite well overall. The finish is black, uniform and slightly rough and is only slightly reflective.Assembly and instructions: 5/5The instructions are simple and adequate. They show various configurations for assembly and speaker-mounting. The rod is in 2 main pieces (the longer rod contains the telescoping extension rod which can be separated if necessary). height adjustment is easy. Both rods are threaded and screw into each other and then to the base. The threads are machined well and are made of metal unlike many stands (like those used for many rotating floor fans). The wire-hiding channel works extremely well. The wire goes through a slit near the top and comes out the bottom of the rod. You can't even tell (unless you're looking hard) that there's a wire at all.Speaker Mounting: 4/5This is the area that could use some improvement. The hardware that comes with the stands works as advertised, is durable, and allows for various configurations, however the hardware for at least one common speaker configuration is missing (and my speakers happen to be these). Many small satellite speakers like the ones that come with the Logitech system have a single hole in the back with threads that are meant for a machine screw. Nothing that I saw in this kit will accommodate this. HOWEVER, I was able to use the threaded-nails that are meant for the base for these speakers by attacking one end (the one with the nail) into the speaker (the threads actually fit) and then using the threaded cap for the other end (see attached photo for example). This configuration seems to be working well. I suggest that the company include hardware (caps with a threaded male end, or a double-threaded screw) for these speakers.OVERALL: 5/5I like these speaker stands very much. They are well-built, sturdy, attractive, small, and cost effective. The range of height adjustment is perfect for most applications. I highly recommend them.

Well, I can’t imagine many stands are easier to assemble than these. I can’t vouch for them on larger speakers, but for really small speakers these fit the bill perfectly, at least for my personal needs.1. Inexpensive but decent build quality2. Tallest I could find, given my speaker size and price range3. Floor base size and overall stand design allows close placement to walls4. Stand poles are robust and fit together well with no wobble (as opposed to being thin and shaky, as were the many other small pole-based stands I previously tried and returned)5. Base is sturdy enough, weighted about right to eliminate excessive wobble with SMALL speakers without weighing a ton.6. Easy assembly with multiple mounting options.7. At least in my case, they arrived with no missing parts, no misaligned holes, no stripped threads.First, let me stress that I used these with SMALL speakers. I paired them with the old Energy Take Classic 5.1 speakers that are ~4” width and depth, ~7” tall. I would NOT use these stands for speakers much larger/heavier than those. I used the horizontal, bottom-of-speaker mounting plate to affix each speaker directly centered over stand poles (as opposed to the L-shaped key hole option for rear speaker mount, also included). Rear mounting the speakers will probably shift their center of gravity off pole-center for all but the tiniest of speakers. I wouldn’t recommend that method, but I didn’t try it, it might work just fine for you. The keyholes in my speakers were too small for the included keyhole screw, anyway. The included under-speaker-bottom mounting plates are small enough to be fully covered by most any speaker without any speaker overhang. The installation pack comes with double sticky sided sponge/felt pads, cut to exactly fit the contour of the base mount plates and has precut screw holes matching those in the mounting plate. You’ll need to supply your own screws if drilling your own holes into your speakers. I wouldn’t use the sticky felt as your only means of final mounting. I think they’re included just to help you keep speakers stuck in place while drilling holes into speaker bottoms and to prevent sonic vibration after final speaker mounting with screws. I wouldn’t trust the sticky felt pads as the only means of attaching my speakers, but you might get away with it if your speakers are tiny and you never bump your speaker stands with any great force.A tri-foot base will never be as stable a four footed base, or a single flat base, but this one is plenty stable for small speakers centered over the speaker pole. The tri-foot base is part of the design-plus that allows close placement to walls, so for me it is an acceptable, minor trade off in form and function. All in all, the base is stable enough.I can’t vouch for the other mounting options I didn’t use. I absolutely would NOT use these stands for heavy speakers, but if you have small speakers of a size and weight to the ones I mentioned above, and you use the bottom-of-speaker mounting plate, these are about the best option you’ll find on amazon at this price point (probably much higher). If you have kids or larger pets that will bump them often, you might want to rethink speaker stands of any kind because there are no stands that can’t be knocked over unless they’re bolted to the floor.Here are a couple mounting tips, should you decide to purchase these speakers:Mounting Tip 1 (for base plate/sticky felt option):Put small strips of masking tape (or similar) on the bottom edge of each speaker side and face before final mounting. Temporarily place speaker in position, on mounting plate (without sticking the sponge/felt pad down yet, or peeling off sticky side protector sheets). Center each side of speaker to pole, by eye. Use a sharpie/marker to mark the tape at pole-center of each speaker side/face. Remove speaker, apply sticky pads to mounting plate. Sit in a chair (or on a stool) in front of the stand with mounting plate at eye level, close enough that you can lean comfortably to see tick marks on tape of each speaker side. Grasp the speaker pole with fingers of one hand as close to mounting plate as possible, one thumb sticking up. Use that hand to steady the pole. While lowering speaker on to sticky pad, use your thumb (now sticking up) as a lever to partially rest the speaker on and to aid in physically guiding the speaker down as you align the center marks you made on the tape to the stand poles. At the same time, use the other hand to hold most of the speaker weight, and slowly lower the speaker onto the sticky pad using the tick marks you made on the tape on each speaker face to line up speaker center to pole. If you drill into your speakers to use screws as well, you’ll still want to press down a little on top of your speaker to keep from pushing the speakers off the sticky pads while drilling from underneath.Mounting Tip 2 (to base plate, no drilling):If you don’t want to drill into your speakers to use the base plate mount, and you don’t trust the included sticky pads to be sticky enough, you can use an alternative attachment method. But honestly, who cares about tiny holes in the bottom of your speakers? It’s the bottom, for Pete’s sake! No one will see them, they won’t hurt or effect speaker performance, and your speakers will never fall off the stand, even if you knock the stand over (unless they physically break off and tear out the screw holes). However, if you’re squeamish about drilling into your speakers, you can purchase Dual Lock strips instead of using screws or trusting the sticky pads. And no, I don’t work for the Dual Lock company, but that stuff is da bomb. (Aside: If you’re a guitarist with a pedal board and you aren’t constantly rearranging your rig, you really want to try Dual Lock). In my book, Dual Lock is a superior alternative to Velcro, if your goal is a kinda-permanent fixture that is rock steady and stuck together like it’s welded... until you don’t want it to be any more. When you want to unstick it, it comes off, but only after no small amount of tugging. I’ve found the adhesive bottom side stays stuck, but peels off when you need it to without damaging surfaces. Instead of “hook and loop” that require male and female strips, its a one part system made of strips with sticky adhesive on the underside (like Velcro) but uses a single type of latching system. The mounting strip (one type used on both things to be stuck together) is covered in tiny interlocking plastic “mushrooms”. Dual Lock, in my experience, has far greater “grab” than Velcro, is a one part fixture instead of 2 parts, and doesn’t wobble around, back and forth like Velcro does. The adhesive side sticks firmly to most surfaces, and stays put even when yanking the “mushroom” sides apart from each other, but doesn’t damage or leave residue when removed. The downside: Once you press two pieces of Dual Lock together, they ain’t comin’ apart without a fight, but that’s what you want anyway. Bigger downside: The stuff ain’t cheap, but it costs less than replacing speakers that wound up in a damaged heap on your floor.

Easy to assemble, the base is sturdy and nice agronomic design. Easy to assemble, handy, lot of screws and accessories provided. Well built, Though they provided hole to send a cable inside the pole, but still the hole is small so couldn't fit my Samsung hw-q990D rear speaker power cable. Otherwise its nice product.

Stable , easy to assemble and well constructed.

These have been great. I've never liked to leave holes on my walls, especially due to how it restricts you from making any change in the room once everything is set. These have worked amazing, they have great stability, the size is great and adjustable depending on your sitting position, and the material used is sturdy with a nice finish.