3" Stainless 90° Mandrel Bend Elbow - 1.5D/4.5" CLR Loose Radius - 16GA/.065" Wall - 2" Leg - SS304 - Exhaust Fabrication

Great quality product, used this and other pieces from the same company to fabricate an LS turbo hot side. Welds really well and the thickness will make it strong enough. Would definitely buy/use again.

Great for fabricating a fuel fill line

great qualilty, they where an excellent choice for the exahust I built

Worked for my turbo dump pipe

The thickness was thicker than specified. About .080. Otherwise it was a very quality bend with a brushed finish inside and out.

These are quality made but do not have 2” legs As stated, measured past the bend radius. 1.5 OD at 1.5D CLR with 2” legs should measure 5” on a square not 3.75” like the one I received. So keep in mind when ordering.

I was very very in shocked did not realize it was that good of metal i used it for my intake on my Mustang on a turbo set up worked out perfect

Beautiful product package nicely and welded great.