ZeroBubble Screen Savers For Resin 3D Printers - Sonic Mega & Mega 8K S

Bought for my Saturn 4 ultra, great product and customer support, will buy again!

Arrived damaged but seller replaced quickly with great communication.

Fits great and saves your screen i would definitely get this to save your screen and anything else underneath the vat or you will be cursing at yourself from not getting this to start off

Great product that protected my printer on multiple occasions. Should ALWAYS be on a resin printer I think.

I had 2 issues trying to install this screen protector.The first issue is the black sealing strips they provide with the screen protector aren't long enough to use a single strip to cover the long sides of the screen. Not a big deal I suppose, just use 2 pieces, but every joint in the tape introduces another possible path for resin to seep past the tap. Because of this, I chose to leave the factory sealing tape in place and put the protector down on top of it. Because the factory sealing tape is thicker, the protector didn't lay down correctly on the screen, leaving a large air gap the entire way around the screen.The 2nd issue is that the sheet is not trimmed to go around the resin auto feed assembly. In order to get the sheet to fit, it has to be cut to clear the auto feeder.

Wish I would have had this day 1 when I purchased a Saturn 2 a year ago. There are some places on the surface of a Saturn 2 where resin can leak down into the guts of the printer. If I had this in place, I wouldn't have had to take my Saturn 2 apart to clean out the inside after a catastrophic fail of the FEP leaking some resin inside. Spend a few extra bucks to save yourself a world of grief and downtime by getting this early.

I had no problems putting these on I put them on and didn't read level my beautiful lady haven't had one problem no field prints at least from these and they working great so far

The screen protector does have a slight gap on the perimeter of my screen, but I don't think there's a way of avoiding that since it isn't flush to the base. I have yet to use my full build plate to see if this effects prints.