Igreeman 20 Pack BNC Male Coaxial Connectors Screw-Lock Terminal Brass Adapter for CCTV Home Security Surveillance Camera RG59 RG6 Video Transmission Coax Cables

They work OK

I'm a professional installer and this is by far the easiest and fastest way to terminate BNCs. Others have complained about the screw stripping. Not true... They must have tightened it too much. A lot of screw pressure is not necessary. Simply snug the screw and correctly crimp the ground/strain relief and this will be the best connector you'll ever deal with.

On the surface these connectors look good, but in practice, they don't hold up.The set screw for the center conductor is made of a soft metal, as is the threaded piece it screws into. As a result, once you reach the wire, you can't tighten the screw down to hold the conductor in. Also, once there's a conductor in the small tube this screw clamps into, the screw no longer goes in far enough, so the screw makes a short circuit with the outer shell of the connector rendering the connection useless. You'd be better served by removing the screw and using the screw hole to solder the center conductor into place.The crimp area for holding the wire does not grab well since you're also grabbing the shielded conductor which gives way too easily. Therefore this does not grab the cable tight enough, even crimped very hard, to stop it from slipping out. If there were teeth to grab through the insulation, it would be better. Again, you'd be better served by soldering the shielding to that outer crimping area.The strings do nothing. They're more decorative than anything else. They are not attached to the shielded cap and as such very easily disengage from it and slide down the wire.These may be ok for a hobbyist, but they will not stand up to regular use in a professional setting.

I found this connector to be extremely easy to use and of very high quality, in contrast to another reviewer's comment that the screw threads tended to strip easily. I did NOT find this to be the case--quite the opposite actually.There are excellent online reviews and tutorials on this connector, just search on "Igreeman 75 ohm Connector Review and Tutorial".

I replaced old BNC connectors and this worked really good and got the job done.

Metal screw inside and surrounding attachment is too soft. I had two out of ten that were stripped in the package. You have to reference the products page to get the assembly instructions.

Just as they should be. Did the job. Thanks

Cheap connectors I will use others in the future, these rust outdoor and are not watertight