Rough Country2.5" Lift Kit w/N3 Shocks for 2018-2023 Jeep Wrangler JL - 67730

No complaints at all. This kit did exactly as described with no issues whatsoever. My Jeep looks much better now and fits 35” tires with no problem at all.

Installed with my buddy in the driveway in less than two hours. 2020 Rubicon JL 2 door. The shocks included in this kit are fantastic compared to the factory rubicon ones. Everything was included including the bump stops and good directions. All you need is two jack stands and a floor jack and you’re good to go. Clears my Toyo Open Country RT’s perfectly. Great job Rough Country!

The rear washer and nut that holds the rear spacer was welded off center. The bolt will not start because it hits the washer.Ran the bolt from the other side to maybe cut a bit of washer with the bolt. It was hard and flattening threads. So pulled it back out. This small problem will leave you at a point of no return. You have to use this to finish the project and your stuck until it's installed.Called rough country. Just to let them know about the issue. I did not want a part shipped or anything. Because I can use a Dremel and grind out the washer to make room for the bolt. Just wanted to make them aware of the minor issue. The rest of the install went perfect. The customer service thanked me for the call.The lift on a rubicon makes it look like you put a 4 inch lift when running 35s. So if your doing 37s.It will still have plenty of wheel well room.The instructions are good, however there are a few steps that you do not need to do to get this installed.For the front. You do not need to unbolt your front drive shaft. And you do not need to unbolt your panhard bar. Only disconnect the sway bar links, brake line and speed sensor brackets & the locker wire. You can get the front installed. Note: do the drivers side first. That way on passenger you have more play to get the spring in when doing that side.For the rear, you will have to unbolt the panhard bar like the instructions say.

Great little kit if you don't want to go SUPER cheap. Watch a YouTube video on how to install. Ride quality is great. Got it installed in an afternoon with some hand tools, jack stands, and some floor jacks. Love the look. Makes my 33's look a bit small....guess it's time for some 35's 😀

The product overall is great, but you will need one more part to maintain the factory ride quality. That part is the control arm relocation bracket. They say you don’t need it for a 2.5 lift but you really do. In my opinion they should slightly raise the cost of the kit and include the relocation arm brackets.

Perfect for my usage... clears 37s on my JL Rubicon and it rides very close to stock... you might need LCA'S to get your caster back... I did... overall, it's a great spacer kit for a JL.

Lift is easy to install with a floor jack and a couple jack stands. I have 35 inch tires but could most likely put up to a 37 with this lift installed. Shocks provide a stiffer ride for sure. Less roll etc.

Very pleased with this lift kit. Wasn’t too bad to put on, maybe 4 hours in the garage with some air tools. Just enough lift to get the bigger and more aggressive look my wife wanted for her Jeep. Great option for the mall-crawler.2018 Wrangler JLUPaired with 33x12.5r17