3D Printing Adhesive 3.0 fl oz (90ml) - Great for ABS, Polycarbonate and MoreF

Awesome product. Put it on thick and part will lift right off once the heated bed cools. Rinse with water reapply for next print. Never had print fail due to lifting once I started using this. Other heat activated glues go bad over time once opened(2-3 months). This one keeps on going till the last drop. Worth every penny

Works great....but way too expensive.

This product works exceptionally well. Easy removal after bed cools.

good stuff

Works perfectly!

I purchased this at another site for use with Ultrafuse Stainless Steel filament. It worked, but sometimes it didn't release, to the point of needing to destroy the print during removal. I'm now using it for printing ABS on glass. Wow... The ABS model was stuck so tight at 100c that I thought it would never release. Was I wrong. At 30c it lifted off the glass as if it was never attached.It does leave a sticky residue on the print, but it washes off easily.

I have used Dimafix bed adhesives for several years (both spray and pen). They provide very good adhesion to a glass printing bed. I have used this adhesive with PLA, PVA, TPU, PC. PETG, and PA with acceptable results. I have used it with PLA parts that took more than 30 hours to print. I prefer the pen because you can place the adhesive just where you need it for smaller parts and it is less messy to apply. This adhesive is water soluble, and sometimes the parts adhere so well that water is the best way to remove them.

Questo fissante per la stampa 3D è indispensabile per ottenere un buon risultato, prima di comprarlo ogni stampa veniva storta e il primo layer non riusciva ad aderire al piano di stampa, con una sola applicazione si possono fare anche più stampe e un tubetto con un uso non assiduo dura più di un anno. Il pacco è arrivato nei tempi previsti come da usuale consegna Amazon e ben imballato. Consiglio a tutti gli amanti della stampante 3D di acquistare questo prodotto che renderà la stampa più facile e migliore.