🔧 Cut Above the Rest!
The Grizzly G1438 Slitting Saw Arbor features a 1/2" shank and compact dimensions of 1.5" x 3.1" x 1.5", weighing only 0.3 lbs, making it an essential tool for precision cutting in various applications.
S**L
Arrived before expected
Looks like it will do the job but would have been nice to have an allen wrench supplied with it ?
M**L
Unusable
I know, I know... I bought a sub-$20 arbor. Seriously though, usable cheapness is fine but I had to take a 0.004" wart off of the shank end just to fit in my 1/2" end mill holder. Ok, no biggie move on. Then the NOS Morse 3"x 0.125" saw I bought this for friggin wobbles AN ENTIRE THICKNESS! As in 1/4" slot, and it's not the saw. All in the flange face, the OD runs true (go figure). The smaller diameter pilots are dinged so far out, you couldn't wreck a blade onto one. I needed this part done ASAP, so I forfeited returnability and trued it up in the lathe to get through the job. Right in the trash, not disgracing my scrap bin with this. At least I got a countersunk screw and tool container for my $17. Nice going Grizzly, re-write that pitch about how you're factories are better. They're worse.
A**R
Okay with inch saws.
1/2" shank fits all standard chucks and collets. Will take slitting saws with 1/2", 5/8", 3/4", 7/8", and 1" arbor holes.Most saws on Amazon have metric inner holes like this (Inner Hole Dia.:22mm/0.86")These don’t work well as the have a lot of run-out. Okay with imperial (inch).
P**T
Use only for one saw.
WHat can I say?It DID hold a saw.It DID let me cut.The runout was BAD. Maybe 1/8th inch.I tried to retrieve my sawblade from this and make my own holder. The allen key was seized so hard in the bore, I could not get it undone. I wrecked two allens and the bolt itself trying to extract my saw. I will have to cut this holder up.
R**C
Does what it is supposed to do.
Does the job, fits a few different size blades. If your trying to use small total diameter blades obviously its a bit big for that but everything I needed it for, its doing just fine. Not sure what the other reviewer was exactly doing wrong but I have no issues with this at all.
R**O
Three Stars
Did not have the size I needed
J**N
Four Stars
Works well for light duty cutting. Worth it for the low price.
T**D
Good concept but wobbled
The media could not be loaded. Wobbled, good concept but the spring system and cap is too generic. It wobbled
L**E
Three Stars
Does the job.
Trustpilot
5 days ago
1 week ago
