034-0094 SANBORN PRESSURE SWITCH 95-125 PSI FOUR PORT UNLOADER VALVE

I didn't realize there were 4 "unloader ports". Worked out well. Tank inlet, pressure gage, over pressure pop off and a spare to my low pressure, filtered, painting air supply. Initial setting was 100psi. Comforting as my failed unit was over 160psi and didn't shut off!

Exactly what I ordered.

No problems, switch replaced fine. All ok

Exact fit works perfectly and the price is awesome compared to the others

Worked perfectly on my very old Sanborn compressor, but . . .On my compressor, the on-off lever had to be bent 90 degrees past its original location for it to fit my compressor. I bent it carefully with vise grips and channel locks. DO NOT try to take the switch apart. These things are a maze inside. I started to take my original switch apart to repair a leak, and it blew up into many pieces. Bottom line, this unit works perfectly, but may require a bit of tinkering to make it fit.

Worked on my old 20gal air compressor, had to buy a plug to close one end of air outlet, was able to install with additional 1/4 in piping to route line as my old system had. For $15 it looked like my old one so I took a chance and it Works Great!!! Saved me for having to buy a new compressor.

Replacement item , works as it should!

Works great! Can’t say it is a perfect match for my compressor but every thing else works great. The reason that it wasn’t a perfect match is because my old one only had one port for the pressure relief valve. Had to buy a couple of plugs to close off the extra ports. I didn’t have to adjust anything just hooked it up and it turns on and off like it is supposed to.