Hayden SuperValve with 110v and Small Door-Almond by B&I

All I needed was the face plate/power connections. Not the whole installation package. Geez.Otherwise, works like a champ.

This replaces the NUTONE valve because it's the company that makes them FOR NUTONE... Identical in every way. In fact the NUTONE website shows their replacement as a Hayden Valve. Don't pay the markup. If your cover cracks, I haven't seen anywhere that sells just the outer cap section. You have to buy the guts too (interior junction box, etc). Unscrew the old cracked door, pull it out, and disconnect the wire nuts to the 120V plug and the low voltage wires for the vacuum. Reconnect to the new Hayden cover, push back in the wall and screw it. That's it.

These look just like the ones that we installed before. Those worked. These should also. Will alter this review if we were to encounter problems. One of the ones we are replacing only lasted 25 years, the others we installed then are still functioning and we were short one, way back then. Finally ordered it, I wouldn't say it is located in a critical location but he already cut the hole and I'm past ready for it to be filled, HA.

We bought this product to replace a broken door on a central vac receptacle. We only used the door (not the rest of the product) so it only took a few minutes to install. It works perfectly! From the research I did, it looks like this could replace a Nutone C1358IV or Supervalve 1750 receptacle. The number on the inside of the door of our original receptacle was LR 61865. If you only need a new door, save yourself some money and buy this product!

I have them all over the house without one problem to be had.