ACCEL9018C Extreme 9000 Spark Plug Wire Set Ceramic Boot

Although these spark plug wires are very well made, the pre-made wire lengths did not work for my Blueprint Engines 383 Stroker. With custom wire looms, two of the wires were about 2" too short and the #1 and #2 wires are at least 12" too long which impacts the appearance. If you have custom headers and a wire loom, opt for the 135 degree universal wires (Accel 9002C - ACCEL Extreme 9000 Ceramic Spark Plug Wire Sets). Although you will need a crimping tool, silicone, and a little patience, these wires will allow you to customize the length, avoid the headers, route through the wire looms, and optimize your engine appearance.

Bought these for a 350 swapped s10. Seem good to go no problems thus far other than i had to shorten nearly all the wires

I don't understand these wires at all

Lengths were off for a couple wires, I shortened them and they now work great.

the wires are great - these are in a 36 ford 350 small block with really tight fitting headers. the high dollar MSD wires lasted almost one hour run time. these wires have been in a long time now and are holding up prefect. no problems with the plug ends at all. the only issue is the lengths of the wires are all goobered up. next set i will buy the kit to make my own wires. but over all these are excellent wires and with stand direct header heat

Bought this new. Just went to install these after sitting them on the shelf for a month and found one of the boots was cracked in several pieces. missed the return window. Ceramic is extremely brittle. The box was taped on all the sides and damaged. Go with silicon. Now I have to contact Accel and get hem to send me a replacement for 1 wire