Skywalker 6” Heavy-Duty Wall Mount Pair for TV Antenna Mast with (2) Brackets with Lag Bolts

The mounts are "good", I'd like to call them great- however I wish they had some teeth/friction texturing to hold a pipe/mast more securely. When I use top quality U-Bolts, the best have notched or stepped "teeth" to bite against a pipe. As mentioned in the title: time will tell if these hold with sufficient grip. I would almost suggest using a weatherproof adhesive after test fitting and being certain of location.

I adapted these to mount a garden hose extension rack that had rusted out at its base and broke off from its cement substrate. These worked so well for this application and I saved over $80 since I did not have to buy a new hose rack, the cement to resink it and the PITA labor digging out the old cement below ground as well!

The part that attaches to the support is slightly bent. The tighter you adjust one or the other, the more it pulls in, allowing vertical adjustment of the mast they are attached to. My mast was leaning slightly to the left and by tightening the screws on the lower bracket, I was able to pull the mast into a vertical upright position. The bolts supplied with the bracket have low tensile strength, care must be taken to not over tighten the bolts or they will shear off. Didn't use the screws supplied with the bracket, used carriage bolts instead to attach the bracket to reinforced fascia board on house.

These work fine though it would be nice if they drilled the holes in the same place. When you put them together, the holes don't line up straight and are slightly off. It doesn't stop them from working, but a tad bit more effort on the manufacturer's part could go a long way.

Perfect for my 1" EMT mast.

I installed a cellular booster in my cabin as the signal inside the cabin was spotty. Where I mounted the antenna mast required at least a 4 inch standoff. Not wanting any contact between the mast and my roof, I ordered these Skywalker Signature Series SKY32813 6" Heavy-Duty Wall Mounts.They are sturdy, hold up to weather, easy to install, and provided the needed clearance. I would buy them again.

Did the job in a tough environment.

The holes for the bolts holding the halves together were drilled about 1/16" off center-pine so when assembled the halves do not match up but are staggered by about 1/8". Does not impact function, just annoying an stupid issue. As a result I had to hammer the the U-bolt to widen it a bit and similarly flatten the U-bolt bracket.