20 Part Formed Greenhouse Overlap Glazing Clips Genuine Elite Greenhouses Parts

I had to replace a pane of glass in my greenhouse and when I went to fit it, I realised the standard clips I had were too short. These ones though, are perfect. Part-formed, you hook the pre-formed end over the lower pane, fit the new pane and bend the end of the clip up.They fit perfectly, are long enough for about 30mm of glass overlap and are easy to bend into shape, without risking glass breakage or feeling like they will come undone.

I noticed in windy weather that lightweight glazing on my new greenhouse was lifting at the bottom. This allowed the wind to get under the glazing and bow it off! Part of the solution was to upgrade the 'w' clips for stronger ones, but this didn't stop the glazing lifting.The answer is these little aluminium clips. They don't look strong enough, but they are and work, very well.

These are brilliant little clips for greenhouse glass that I wish I'd discovered sooner. After some years of struggling to fit slightly imprecisely-cut greenhouse glass using the regular z-shaped clips, I found these little gems! Because they're partly-formed, you can bend them to exactly the length you need for a good fit. They bend easily (no pliers required, just with your thumb) but seem easily sturdy enough to stand up to the job. I'd certainly recommend.

Totally forgot i had ordered these then they turned up at the right time!Storing with my spare parts as i’m sure they will be needed again

It's the versatility of this that gives you the leeway to use slightly less precise glass panels on a greenhouse.

Very easy to use and great for dealing with larger than normal overlaps on glass.

Perfect fit. Allowed me to re-set falling glass panes and set replacement panes as well. Recommended.

As the glass was cut 'too tight' the rigid type wouldn't fit without great difficulty so the part formed and bendable type saved the day..